Assessment of lacustrine/fluvial clays as liners for waste disposal (Lake Van Basin, Turkey)

Ateş, Yusuf; Yakupoğlu, Türker

doi:10.1007/s12665-011-1512-z

Cited by 3 publications

(1 citation statement)

References 16 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Sinistral-slip NAFZ and dextral-slip EAFZ join the Karliova Triple Junction (KTJ) located in Eastern Anatolia [61]. Many fault lines in Turkey have developed due to this active continental collision [59,[62][63][64][65][66]. Both Bitlis-Zagros Suture Belt and Karliova Triple Junction are close to Bitlis province.…”

Section: Tectonics and Seismicity Of Bitlismentioning

confidence: 99%

A Comparative Probabilistic Seismic Hazard Analysis for Eastern Turkey (Bitlis) Based on Updated Hazard Map and Its Effect on Regular RC Structures

Işık

Harirchian

2022

Buildings

View full text Add to dashboard Cite

Determining the earthquake hazard of any settlement is one of the primary studies for reducing earthquake damage. Therefore, earthquake hazard maps used for this purpose must be renewed over time. Turkey Earthquake Hazard Map has been used instead of Turkey Earthquake Zones Map since 2019. A probabilistic seismic hazard was performed by using these last two maps and different attenuation relationships for Bitlis Province (Eastern Turkey) were located in the Lake Van Basin, which has a high seismic risk. The earthquake parameters were determined by considering all districts and neighborhoods in the province. Probabilistic seismic hazard analyses were carried out for these settlements using seismic sources and four different attenuation relationships. The obtained values are compared with the design spectrum stated in the last two earthquake maps. Significant differences exist between the design spectrum obtained according to the different exceedance probabilities. In this study, adaptive pushover analyses of sample-reinforced concrete buildings were performed using the design ground motion level. Structural analyses were carried out using three different design spectra, as given in the last two seismic design codes and the mean spectrum obtained from attenuation relationships. Different design spectra significantly change the target displacements predicted for the performance levels of the buildings.

show abstract

Section: Tectonics and Seismicity Of Bitlismentioning

confidence: 99%

A Comparative Probabilistic Seismic Hazard Analysis for Eastern Turkey (Bitlis) Based on Updated Hazard Map and Its Effect on Regular RC Structures

Işık

Harirchian

2022

Buildings

View full text Add to dashboard Cite

show abstract

Estimation of the phenolic waste attenuation capacity of some fine-grained soils with the help of ANN modeling

Pal

Mukherjee

Ghosh

2013

Environ Sci Pollut Res

View full text Add to dashboard Cite

In the present investigation, batch experiments were undertaken in the laboratory for different initial phenol concentration ranging from 10 to 40 mg/L using various types of fine-grained soils namely types A, B, C, D, and E based on physical compositions. The batch kinetic data were statistically analyzed with a three-layered feed-forward artificial neural network (ANN) model for predicting the phenol removal efficiency from the water environment. The input parameters considered were the adsorbent dose, initial phenol concentration, contact time, and percentage of clay and silt content in soils. The response output of the ANN model was considered as the phenol removal efficiency. The predicted results of phenol removal efficiency were compared with the experimental values as obtained from batch tests and also tests for goodness of fitting in ANN model with experimental results. The estimated values of coefficient of correlation (R = 0.99) and mean squared error (MSE = 0.006) reveals a reasonable closeness of experimental and predicted values. Out of five different types of soil, type E exhibited the highest removal efficiency (31.6 %) corresponding to 20 mg/L of initial phenol concentration. A sensitivity analysis was also carried out on the ANN model to ascertain the degree of effectiveness of various input variables.

show abstract

Removal of Cu(II) and Cd(II) ions from aqueous solutions using local raw material as adsorbent: a study in binary systems

Caliskan¹,

Söğüt²,

Savran³

et al. 2017

Desalination and Water Treatment

View full text Add to dashboard Cite

Assessment of lacustrine/fluvial clays as liners for waste disposal (Lake Van Basin, Turkey)

Cited by 3 publications

References 16 publications

A Comparative Probabilistic Seismic Hazard Analysis for Eastern Turkey (Bitlis) Based on Updated Hazard Map and Its Effect on Regular RC Structures

A Comparative Probabilistic Seismic Hazard Analysis for Eastern Turkey (Bitlis) Based on Updated Hazard Map and Its Effect on Regular RC Structures

Estimation of the phenolic waste attenuation capacity of some fine-grained soils with the help of ANN modeling

Removal of Cu(II) and Cd(II) ions from aqueous solutions using local raw material as adsorbent: a study in binary systems

Contact Info

Product

Resources

About