Arm current reversal‐based modular multilevel DC‐DC converter

Abstract

Nowadays, most of the converters used in high-power high-voltage (HV) applications are the conventional modular multilevel converters (MMC). However, in the case of DC-DC conversion, an imbalance of the capacitor voltages occurs and the conventional MMC fails to operate correctly. This paper introduces an arm current reversal-based modular multilevel DC-DC converter, which successfully provides balance among the capacitor voltages while operating in DC-DC conversion. The proposed configuration is used in medium voltage DC grids to feed DC loads or to interconnect between two DC grids of different voltage levels. The proposed converter is a two-stage DC-DC modular converter, which consists of a single-phase half-bridge MMC with half-bridge submodules (HBMMC) followed by a single-phase H-bridge MMC with half-bridge submodules (SMs). The operational concept of the proposed converter is based on reversing the arm current direction and reversing the output terminals with the help of the H-bridge MMC stage, which ensures the same direction of the voltage at the load terminals. The proposed converter provides a high conversion ratio, bidirectional power flow, simple architecture, and a simple control scheme. Detailed illustrations, analysis, and design of the proposed converter are presented. Besides, MATLAB-based and Opal RT-based simulation results and experimental results are presented to validate the proposed configuration claims. This is an open access article under the terms of the Creative Commons Attribution License, which permits use, distribution and reproduction in any medium, provided the original work is properly cited.

A hybrid half‐bridge submodule‐based DC–DC modular multilevel converter with a single bidirectional high‐voltage valve

“…In [23], the arm current reversal concept has been presented for one-leg half-bridge SM-based DC-DC MMC, where two successive stages are employed, namely, the DC-AC stage to generate square wave AC output voltage and AC-DC rectification stage. Both stages are based on half-bridge SMs.…”