Analysis on Coordination of Over-Current Relay Using Voltage Component in a Power Distribution System With a SFCL

Lim, Sung-Hun; Lim, Sung Hun

doi:10.1109/tasc.2019.2904668

Cited by 24 publications

(15 citation statements)

References 9 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In this study, a new application of waveletbased artificial neural networks that overcome this shortcoming is presented [16]. In another study on SFCL, a stochastic approach is presented for evaluating transient recovery voltages induced along the Circuit Breaker poles of the simple test line equipped with SFCL [17].In a similar study, a method has been proposed that uses the voltage component as the effective parameter of the overcurrent protection relay to protect the power distribution system with SFCL [11]. In a study to analyze the effectiveness of SFCL, the applicability of different SFCLs in the voltage source converter based DC system according to the transient characteristics of the dc failure has been analyzed [18].…”

Section: Related Workmentioning

confidence: 99%

“…The SFCL is one of the methods used to control power fluctuations of micro grids in case of failure. In SFCL, there is no power loss during normal sensing time and provides rapid limiting operation within a quarter cycle without additional sensing device [11]. In order to minimize the damage caused by symmetrical and asymmetrical faults that may occur in power systems to loads, transmission lines and its components, the smart grid architecture that can operate in island mode with correct protection schemes is required.…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Autonomous Operation of Microgrid and Minimization of Fault in Case of Failure in High-Voltage Lines

et al. 2020

View full text Add to dashboard Cite

Highlights  The algorithms that make autonomous maneuver management to the grid have been developed in case of symmetrical and asymmetrical faults in high voltage lines.  The autonomous islanding mode operation has been carried out during the faults in order to prevent the consumers from being affected by faults.  The energy management has been made according to the energy production amount of the distributed generation resources, when the designed microgrid started operating in islanding mode in the fault case.  The SFCL has been designed to prevent damage to the loads and other components in the microgrid while the current characteristics of PV power supply change in case of faults during entry-exit to island mode.

show abstract

Section: Related Workmentioning

confidence: 99%

Section: Introductionmentioning

confidence: 99%

Autonomous Operation of Microgrid and Minimization of Fault in Case of Failure in High-Voltage Lines

et al. 2020

View full text Add to dashboard Cite

show abstract

“…Lim et al [8] have offered R-SFCL coordination with overcurrent relay, in this work overcurrent relay is used as voltage component and reduced the relay tripping time here they concentrate only relay time limiting, not concentrating on the stability.…”

Section: Literature Reviewmentioning

confidence: 99%

Improvement of transient stability in microgrids using RSFCL with series active power filter

Rao

Rosalina

2019

SN Appl. Sci.

View full text Add to dashboard Cite

Now a day's non-conventional energy sources like PV power and Wind power sources are well developed because conventional energy sources are reduced day by day and at the same time the population has been increased. These drawbacks can be overcome by developing the microgrids. In current trends, microgrid protection is a very challenging task. Due to the interconnection of several distributed generators, fault currents are produced. Resistive type superconducting fault current limiter is used for the protection of microgrids because its operating time is very less, it stops the abnormal currents with in the first cycle and continuity of supply is possible. But R-SFCL had some disadvantages, it is not compensated for the reactive power. Then voltage levels are not compensated, for that reason series active power filters are used along with R-SFCL. Here series active power filters are compensating the voltage magnitudes and reduce the harmonics and then transient stability is improved in the microgrids. This work is done using MATLAB/Simulink.

show abstract

“…On the other hand, the second strategies focus on improving the protection systems to cope with the protection problems related to DG integration in the micro‐grids. In this regard, different measures are proposed consist of applying fault current limiters (FCLs) to improve the DG's fault ride‐through (FRT) capability, 9,10 using the new and programmable protection devices, 11‐13 proposing different protection schemes based on distance, differential or directional relays, 14‐18 and applying the communication systems for improving the performance of the protection systems 19,20 . While the first strategies can solve the protection issues, it may bring adverse impacts on the performance of the power system.…”

Section: Introductionmentioning

confidence: 99%

A novel adaptive protection coordination scheme for radial distribution networks in the presence of distributed generation

Bisheh

Fani

Shahgholian

2021

Int Trans Electr Energ Syst

View full text Add to dashboard Cite

Summary Developing micro‐grids and increasing penetration of distributed generation (DG) bring significant techno‐economic benefits to power systems. However, the presence of DG can affect the performance of the protection system. In particular, the coordination of over‐current protection relays in the presence of DGs is a challenging task. In this article, an adaptive algorithm is proposed for protection coordination of over‐current relays. Once the coordination of relays is disturbed due to the presence of DG, the characteristic curve of the backup relay is adaptively modified based on the characteristic curve of the main relay in such a way that the coordination time interval (CTI) be in the acceptable range and therefore the coordination of relays is maintained. The proposed algorithm can maintain the coordination of over‐current relays locally only by controlling current parameter of backup relay and without imposing any restriction on the output power of DGs. Therefore, the proposed protection coordination scheme allows system operators and DG owners to exploit DG benefits without concerning about protection aspects related to the presence of DGs. The efficiency and applicability of the proposed method are validated using simulations on a typical industrial 20 kV radial distribution system. The simulation results show that the proposed algorithm can maintain the CTI of the main and backup relays in an acceptable range for various penetration levels of DGs.

show abstract

Analysis on Coordination of Over-Current Relay Using Voltage Component in a Power Distribution System With a SFCL

Cited by 24 publications

References 9 publications

Autonomous Operation of Microgrid and Minimization of Fault in Case of Failure in High-Voltage Lines

Autonomous Operation of Microgrid and Minimization of Fault in Case of Failure in High-Voltage Lines

Improvement of transient stability in microgrids using RSFCL with series active power filter

A novel adaptive protection coordination scheme for radial distribution networks in the presence of distributed generation

Contact Info

Product

Resources

About