Analysis of post-processing influence on the geometrical and dimensional accuracy of selective laser melting parts

Abstract

Purpose This study aims to analyze the effect of the different common post-processes on the geometrical and dimensional accuracy of selective laser melting (SLM) parts. Design/methodology/approach An artefact has been designed including cubic features formed by planar surfaces orientated according to the machine axes, covering all the X-Y area of the working space. The artefact has been analyzed both geometrically (flatness, parallelism) and dimensionally (sizes, distances) from coordinate measuring machine measurement results at three stages, namely, as-built, after sand-blasting and after stress-relieving heat treatment. Findings Results from the SLM machine used in this study lead to smaller parts than the nominal ones. This effect depends on the direction of the evaluated dimension of the parts, i.e. X, Y or Z direction and is differently affected by the sandblasting post-process (average erosion ratio of 68, 54 and 9 µm, respectively), being practically unaltered by the HT applied after. Originality/value This paper shows the influence, from a geometric and dimensional point of view, of two of the most common post-processes used after producing SLM parts, such as sand-blasting and stress-relieving heat treatment, that have not been considered in previous research.

Study on Chemical Graft Structure Modification and Mechanical Properties of Photocured Polyimide

“…The results are shown in Figure . The result shows that the thermal decomposition temperatures − of linear PI and fully aromatic PI are significantly different. Compared with linear PI, the thermal decomposition temperature of all-aromatic polyimide is linear PI, mainly because all-aromatic PI has more benzene rings and a stable structure, which requires a higher temperature to break its bond energy.…”

Influence of stress-relieving heat treatments on the efficacy of Co-Cr-Mo-W alloy copings fabricated using selective laser melting

“…The fit between the abutment tooth and restoration changes based on the distortion produced by the post-processing thermal treatment [41]. The distortion of the marginal fit during firing cycles is caused by several factors such as thermal shrinkage caused by changes in temperature, sintering shrinkage caused by densification, and alloy shrinkage [36,42]. In this study, metal copings subjected to high-temperature post-heat treatment exhibited dimensional changes or distortions owing to thermal shrinkage, which negatively affected the marginal fit of metal-ceramic restorations.…”

Additive manufacturing of anti-SARS-CoV-2 Copper-Tungsten-Silver alloy

“…Whilst the process is relatively straightforward for solid geometry, for porous geometries, the number of data points increases exponentially in line with the resolution of the porous architecture required. This leads to significant challenges associated with preprocessing, leading to alterations in the file format resolution, error fixing (bad edges, overlapping and intersecting triangles) and slicing parameter inconsistencies leading to print defects when using the conventional technique (Leirmo et al, 2020;Huotilainen et al, 2014;Cuesta et al, 2020). The excellent agreement between predicted and actual data also shows the accuracy and consistency of the parameter informed technique, which is also a challenge when working with high-resolution STL files with large data points.…”