An Investigation on the Effects of Subnet Extension on Delay and Throughput in Network-on-Chip

Abstract

When designing a system-on-chip (SOC), a network-on-chip (NOC) paradigm is the backbone of used interconnection, but in recent years, with a great improvement in silicon technology and the ability to implement billions of transistors on a wafer, it sounds that wire-based communication is not efficient any longer, therefore designers intend to replace wireless transferring data methodology instead. In the following, we show how the performance of the wireless network is improved with subnet extension. This paper focuses on the evaluation of delay and throughput which are two important factors in network proficiency. In fact, to enhance the performance of the system, we need to reduce the number of delay cycles and improve the throughput, therefore to keep balance between these two parameters, designer has to adjust the packet injection rate (PIR) in a safe margin such that it does not exceed a certain point in each state, otherwise delay is uncontrollable, thus it is required to clearly identify the take-off points. About the designer also has to be informed purpose for which the system is going to be designed. It strictly depends on whether high throughput or low delay cycle is desirable. Subnet extension is a way to achieve this target. Here, totally three networks with the number of cores 64, 512 and 1024 have been selected, respectively. The effect of subnet extension is evaluated on each one. The behavior of each network with different number of subnets and IPs is studied. Obtained results from the simulator for different ranges of PIR and subnets are significant. To emphasize, we highlight the take-off points for the delay cycles and the points which does not cross the PIR level. Performance evaluation is conducted based on flit-accurate and open source system C simulator BookSim.

A New Methodology in Study of Effective Parameters in Network-on-Chip Interconnection’s (Wire/Wireless) Performance

“…However, as the architecture is improved to enhance the performance of the system, their increasing complexity makes their design extremely challenging. Furthermore, another parameter which is important to be studied is traffic generated between components and traverse the OCI [10]. Therefore, it is very helpful to perform a traffic analysis and predict the process in early stages of the design to determine an appropriate traffic model, such that the designer can select suitable parameters for the on-chip interconnect architecture.…”