An analog sinusoidal frequency-to-voltage converter

Surakampontorn, W.; Chonbodeechalermroong, Y.; Bunjongjit, S.

doi:10.1109/19.119769

Cited by 16 publications

(2 citation statements)

References 9 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Applications of the scheme include measuring peak voltage, power factor, reactive power, and the control loop of an active power filter. Notably, for applications that require extending the operating frequency range, the proposed phase shifter can easily be extended with a high performance frequency-to-voltage converter [7].…”

Section: Discussionmentioning

confidence: 99%

A Novel Unity-Gain Phase Shifter for Measuring Power System Quantities

Jiang

2014

AMR

View full text Add to dashboard Cite

The paper presents a novel unity-gain phase shifter. Based on the voltage control all-pass filter using an analogue multiplier along with a frequency-to-voltage converter, this approach can theoretically both provide unity-gain and maintain a predetermined phase shift constant over a wide frequency range. As no complicated calculation circuit is required, the proposed scheme can be implemented using a simple hardware circuit. Some experimental results are provided to verify the validity of the proposed scheme.

show abstract

Section: Discussionmentioning

confidence: 99%

A Novel Unity-Gain Phase Shifter for Measuring Power System Quantities

Jiang

2014

AMR

View full text Add to dashboard Cite

show abstract

“…The FVC designed by A Djemouai [2] is chosen for implementation because it consumes only a small area and it is able to provide outputs without ac ripples. These two conditions is important especially for the gas sensor signal processing circuitry where area and noise are some of the main concerns [3]. The practical current source designed here applies the bootstrap bias technique.…”

Section: Frequency To Voltage Convertermentioning

confidence: 99%

Design and implementation of interface circuitry for cmos-based saw gas sensors

Yasin

Tye

Reaz

2005 Joint 30th International Conference on Infrared and Millimeter Waves and 13th International Conference on Terahertz Electr

View full text Add to dashboard Cite

The design and development of interface circuitries for CMOS-based SAW gas sensor is presented in this paper. The SAW sensor devices typically run at RF, requiring most design to have complex signal conditioning circuitry.Our approach attempt to design a simple architecture with reduced power consumption. The SAW sensors operate at 354MHz. Simulation data show that the interface circuitries are ten times smaller with lower power supply, compare to existing work.

show abstract

A Novel High-Performance BiCMOS F/V Converter for Low-Frequency Signal Processing Systems

Yan

Yang

et al. 2011

Advanced Electrical and Electronics Engineering

View full text Add to dashboard Cite

An analog sinusoidal frequency-to-voltage converter

Cited by 16 publications

References 9 publications

A Novel Unity-Gain Phase Shifter for Measuring Power System Quantities

A Novel Unity-Gain Phase Shifter for Measuring Power System Quantities

Design and implementation of interface circuitry for cmos-based saw gas sensors

A Novel High-Performance BiCMOS F/V Converter for Low-Frequency Signal Processing Systems

Contact Info

Product

Resources

About