Alphasat experiment at Aveiro

Rocha, Armando; Pereira, Tiago; Mota, Susana; Jorge, Flavio

doi:10.1109/eucap.2016.7482017

Cited by 6 publications

(2 citation statements)

References 4 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Many setups, e.g., [ 18 , 32 ], including ours, also perform an additional calculation of the overall power at the baseband (from

). The purpose of this is to help identify rain events.…”

Section: Methodsmentioning

confidence: 99%

“…Although it has not been installed in our system, it is interesting to note that thermal effects on the unit electronics can be partially compensated for by using Peltier cells attached to the LNB metal enclosure, as in [ 18 ]. A good approach to using this technique is to keep the LNB at a constant temperature of, for example,

C. In the referenced case, this was easier because their receiver was totally located indoors looking at AlphaSAT through a millimeter wave transparent window, while our Radio-Frequency (RF) unit was outdoors ( Section 2.1.1 ).…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Low-Cost Ka-Band Satellite Receiver Data Preprocessing for Tropospheric Propagation Studies

Santos

Machado

Nandi

et al. 2022

Sensors

View full text Add to dashboard Cite

Satellite tropospheric propagation studies strongly rely on beacon receiver measurements. We were interested in performing a measurement campaign to characterize rain attenuation statistics. In this article, we outline some of the characteristics and drawbacks one faces when trying to perform a radio wave satellite beacon propagation experiment at the Ka-band with low-cost measurement equipment. We used an affordable beacon receiver consisting of a commercial low-noise block down-converter, an outdoor dual-reflector antenna, and a software-defined radio unit. To measure rain attenuation events, we needed to work out where the reference signal level was at all times. However, as we did not have a radiometer to remove the impact of gases and clouds, since it is a very expensive device, we used a procedure that involved the subtraction of a stable and reliable reference level (template) from the raw received beacon level. This template was extracted from observations during non-rainy periods. The procedure implemented for extracting the template was based on the same data processing methodology used by other authors in this field. Here, we describe through specific examples the main characteristics of the templates extracted on non-rainy days, as well as the impact of some meteorological parameters and unavoidable, but small antenna pointing errors.

show abstract

“…Many setups, e.g., [ 18 , 32 ], including ours, also perform an additional calculation of the overall power at the baseband (from

). The purpose of this is to help identify rain events.…”

Section: Methodsmentioning

confidence: 99%