A thermal processing map of a ZrCuNiAlEr bulk metallic glass in the supercooled liquid region

Li, Chunyan; Yin, Junjun; Ding, Juanqiang; Zhu, Fuping; Xu, Fei; Zhao, Yuhong; Kou, Shengzhong

doi:10.1007/s10853-019-03363-5

Cited by 11 publications

(1 citation statement)

References 9 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…And J reaches its maximum value when the value of m reaches 1. Therefore, Jmax = sε /2 [28]. Thus, the efficiency of power dissipation ηp, i.e., ηp = J/Jmax = 2m/(m + 1), represents the ratio of the energy dissipated via structural transformation.…”

Section: Thermoplastic Forming Mapmentioning

confidence: 99%

Superplastic Forming of Zr-Based Bulk Metallic Glasses

Zhang,

Zhao,

Xiao

et al. 2023

Metals

View full text Add to dashboard Cite

In this paper, the partially crystallized Zr70Cu13.5Ni8.5Al8 bulk metallic glasses (BMGs) were prepared, and their superplastic deformation ability in the supercooled liquid region was studied via compression over a wide range of strain rates from 5 × 10−4 s−1 to 1 × 10−2 s−1. It has been found that the superplastic deformation behavior of the BMGs is strongly dependent on the strain rate and temperature. The flow behavior of the BMGs transformed from Newtonian fluid to non-Newtonian fluid with the increase in the strain rate and the decrease in temperature. Based on the high-temperature compression results, a thermalplastic forming map was constructed, and the optimal superplastic forming parameters were obtained. Then, gears were successfully extruded using part of the optimal thermal processing parameters. Further studies showed that high-temperature extrusion induced the crystallization of the BMGs, which increased the microhardness of the gears.

show abstract

Section: Thermoplastic Forming Mapmentioning

confidence: 99%