A survey of multiport converters used in renewable energy

Al-Chlaihawi, Sarab; Al-Gizi, Ammar

doi:10.1109/isfee.2016.7803185

Cited by 8 publications

(2 citation statements)

References 15 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…These converters present dynamic performance due to centralizes control of power integration and it has the advantages including less components, lower cost, economical, reliable and better dynamic performance [2]. Due to the advantages of the configuration of multiport converters, it has been used in different applications such as interface with a renewable energy source as shown in the survey presented in [3]. Comparative dynamic analysis of different multiport converters including a Dual Input Single Output converter without a transformer, a Three-Port Full and Half-Bridge converters, with transformer isolation for interfacing the renewable energy sources such as photocell along with the energy storage devices.…”

Section: Introductionmentioning

confidence: 99%

Power Flow Management in Photovoltaic Energy System Using Multiport DC-DC Converter

Al-Chlaihawi¹,

Ali²,

Alrubei³

2020

Proceedings of the Proceedings of the 1st International Multi-Disciplinary Conference Theme: Sustainable Development and Smart

View full text Add to dashboard Cite

In this paper, the power flow controller for multi-port DC-DC converter was modified, so it mediator a photocell, a storage element and an isolated load. The MOSFET switches are used to design the presented model to manage the flowing power of load voltage and two sources independently. Theoretical researches are implemented to prove the capability of the controllers to regulate the flowing of power for the photovoltaic generator and the storage element while maintaining the load in three cases. First, the photovoltaic power is greater, less and equal to load resistance and maintaining the switches in the best condition for each case. Finally, the power of the photovoltaic generator follows the direction proposed by the MOSFEST switcher's control.

show abstract

Section: Introductionmentioning

confidence: 99%

Power Flow Management in Photovoltaic Energy System Using Multiport DC-DC Converter

Al-Chlaihawi¹,

Ali²,

Alrubei³

2020

Proceedings of the Proceedings of the 1st International Multi-Disciplinary Conference Theme: Sustainable Development and Smart

View full text Add to dashboard Cite

show abstract

“…In [2] an overview is presented regarding multiport converters. The first section contains the information of multiport converter introduction.…”

Section: Introductionmentioning

confidence: 99%

The Analysis and Comparison of Multiport Converter used for Renewable Energy Sources

Al-Chlaihawi¹,

Al-Gizi²,

Crăciunescu³

2017

Adv. sci. technol. eng. syst. j.

View full text Add to dashboard Cite

The concept of renewable energy is increasing day by day because the electrical applications are moving towards utilization of renewable sources and due to this factor electric power is also gaining ground and new type of converters are modelled in order to get high utilization of renewable sources. In this paper, two types of multiport converters are presented which includes a DC-DC converter with a transformer attached and a DC-DC converter without a transformer. The converter with transformer is further subdivided into a full bridge and a half bridge DC-DC converter. The simulation results for all converters are presented and in the end, a case is taken for comparison which involves fixed resistance. The converters are compared with a constant load resistance of 70 ohms in terms of cost, area, complexity, control, isolation, weight and efficiency etc.

show abstract

Fuzzy Logic Power Flow Control in divide Full Bridge Three-Port Converter

Al-Chlaihawi

Alrubei

Al-Gizi

et al. 2020

IOP Conf. Ser.: Mater. Sci. Eng.

View full text Add to dashboard Cite

On this work, the three-port converter derivative from the full-bridge converter is analysed and control. The full-bridge converter is made up of two parts, A and B. Each part contains two switches with independent input sources. The inputs drive the load through a transformer that boosts voltage and provides isolation. The controller is an important portion of the converter. It controls the pass of power between the three ports. The controller uses Fuzzy Logic Control to make decisions regarding the two control signals for each part. These decisions are based on the variance between the whole energy generated by the photovoltaic panel and the energy demand at the load. The proposed design is verified through MATLAB and Simulink.

show abstract

A survey of multiport converters used in renewable energy

Cited by 8 publications

References 15 publications

Power Flow Management in Photovoltaic Energy System Using Multiport DC-DC Converter

Power Flow Management in Photovoltaic Energy System Using Multiport DC-DC Converter

The Analysis and Comparison of Multiport Converter used for Renewable Energy Sources

Fuzzy Logic Power Flow Control in divide Full Bridge Three-Port Converter

Contact Info

Product

Resources

About