A power combined W-band HBT oscillator

Uchida, Kenji; Matsuura, Hiroyuki; Yakihara, T.; Kobayashi, S.; Oka, Shinichiro; Fujita, T.; Miura, Akira

doi:10.1109/mwsym.2000.860883

Cited by 3 publications

(2 citation statements)

References 5 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In our simulations we used the models given in Ref. 10 for each kind of transmission line structure shown in the figure, that is, the shorted stubs, T-junctions, and cross-junctions.…”

Section: Power Combiningmentioning

confidence: 99%

See 1 more Smart Citation

A 100‐GHz‐band quadruple power combined monolithic HBT oscillator

Uchida

Matsuura

Yakihara

et al. 2003

Electron Comm Jpn Pt II

View full text Add to dashboard Cite

SUMMARYIn this paper we discuss a design methodology we used to fabricate a 100-GHz-band monolithic oscillator that power-combines four heterojunction bipolar transistor (HBT) based suboscillators, and the experimental results we obtained. We analyzed the oscillation condition by considering the loop gain when feedback is present, and adjusted the design parameters so as to combine the output powers of four suboscillators by making them oscillate in phase. The active elements we used for the suboscillators were InGaP/InGaAs HBTs with emitter dimensions 1.0 µm × 5.0 µm, for which f T and f max were 190 and 240 GHz, respectively. The signal frequency of the completed oscillator was 97. 4 GHz, its output power +3.0 dBm. The biases on the HBTs were I C = 10 mA and V CE = 2.0 V. In order to discuss the power combining efficiency, we fabricated test oscillators with only one and dual power combined oscillators, which were investigated under the same measurement conditions. These circuits oscillated at 100.5 and 100.4 GHz, respectively, with -3.2 and -0.4 dBm output powers. These results confirm that the output power increases with the number of suboscillators. As far as we know, our article is the first to report a monolithic oscillator that power-combines four suboscillators.

show abstract

“…In our simulations we used the models given in Ref. 10 for each kind of transmission line structure shown in the figure, that is, the shorted stubs, T-junctions, and cross-junctions.…”

Section: Power Combiningmentioning

confidence: 99%

“…To accomplish this, in Ref. 10 we proposed an oscillator design based on power-combining the fundamental-wave output power of two suboscillators. In this oscillator design, we first connected the bases of the two suboscillator HBTs at one point, and then made them oscillate in-phase.…”

Section: Introductionmentioning

confidence: 99%