A multifunctional DSTATCOM for power quality improvement

Mahdianpoor, Mohammad; Kiyoumarsi, Arash; Ataei, Mohammad; Hooshmand, Rahmat‐Allah; Karimi, Houshang

doi:10.3906/elk-1505-260

Cited by 5 publications

(4 citation statements)

References 19 publications

(32 reference statements)

Supporting

Mentioning

Contrasting

Order By: Relevance

“…A STATCOM has its control algorithm as the most vital component as it is involved in dynamic reactive power control. The best compensation effect can be obtained by proper control of the STATCOM [9][10][11]. Conventionally, a STATCOM is controlled by a PI controller; several works exist on the control of STSTCOM using PI controllers.…”

Section: Introductionmentioning

confidence: 99%

Enhancement of cascaded multi-level VSC STATCOM performance using ANN in the presence of faults

Almelian¹,

Mohd²,

Ahmad³

et al. 2020

IJPEDS

View full text Add to dashboard Cite

A system can be disturbed in terms of stability when connected to a number of loads at the distribution ends or when subjected to faults. To reverse such systems to a stable state, FACTS devices such as static synchronous compensator (STATCOM) are used. In this paper, a cascaded multi-level voltage source converter (VSC) STATCOM was designed and implemented with a novel space vector pulse width modulation (SVPWM) scheme. Artificial neural network (ANN) controller was used instead of instead of Proportional-Integral (PI) controller in the proposed scheme to improve the response time (RT) and performance of STATCOM in terms of power factor (PF) and voltage amplitude during periods of voltage sag. During the implementation, two fault sources (single-line-to-ground (SLG) and line-to- line (LL) faults) were used to create voltage sag. STATCOM was subjected to performance evaluation in the presence of these disturbances via MATLAB simulation in IEEE 3-bus system. The outcome of the simulation studies showed the ANN controller to perform better than PI as it was able to rapidly recover voltage value (<1 cycle) with unity PF.

show abstract

Section: Introductionmentioning

confidence: 99%

Enhancement of cascaded multi-level VSC STATCOM performance using ANN in the presence of faults

Almelian¹,

Mohd²,

Ahmad³

et al. 2020

IJPEDS

View full text Add to dashboard Cite

show abstract

“…With the advancement of microprocessor and semiconductor technology, cascaded multilevel VSC-based custom power devices have been introduced in distribution systems. STATCOM is a VSC-based custom power device and meets the load current compensation requirements such as reactive power compensation [4][5][6].…”

Section: Introductionmentioning

confidence: 99%

Enhancing the performance of cascaded three-level VSC STATCOM by ANN controller with SVPWM integegration

Almelian¹,

Mohd²,

Ahmad³

et al. 2019

IJECE

View full text Add to dashboard Cite

This article presents a cascaded three-level voltage source converter (VSC) based STATCOM employing an artificial neuron network (ANN) controller with a new simple circuit of space vector pulse width modulation (SVPWM) technique. The main aim of utilizing ANN controller and SVPWM technique is to minimize response time (RT) of STATCOM and improve its performance regard to PF amplitude, and total harmonic distortion (THD) of VSC output current during the period of lagging/leading PF loads (inductive/capacitive loads). The performance of STATCOM is tested using MATLAB/SIMULINK in IEEE 3-bus system. The simulation results clearly proved that the STATCOM with intelligent controller is more efficient compared to a conventional controller (PI controller), where ANN enables the voltage and current to be in the same phase rapidly (during 1.5 cycles) with THD less than 5%.

show abstract

“…The control algorithm is the most important part of a D-STATCOM used for dynamic control of * Correspondence: hakanacikgoz@kilis.edu.tr reactive power. The best compensation effect can be obtained by control of the D-STATCOM properly [2,5].…”

Section: Introductionmentioning

confidence: 99%

“…A distribution static compensator (D-STATCOM) is an inverter-based custom power device and meets the load current compensation requirements such as reactive power compensation, load balancing, and harmonic elimination, as well as voltage regulation under balanced and unbalanced loads [1][2][3][4].…”

Section: Introductionmentioning

confidence: 99%

Real-time implementation of three-level inverter-based D-STATCOM using neuro-fuzzy controller

Çöteli¹,

Açıkgöz²,

Dandil³

et al. 2018

Turk J Elec Eng & Comp Sci

View full text Add to dashboard Cite

A distribution static compensator (D-STATCOM) is a custom power device connected in parallel to a power system to address electric power quality problems caused by reactive power and harmonics. To obtain high performance from a D-STATCOM, the D-STATCOM's dq-axis currents must be controlled in an internal control loop. However, control of the D-STATCOM's currents is difficult because of its nonlinear structure, cross-coupling effect between the dand q-axis, undefined dynamics, and fast changing load. Therefore, the controller to be preferred for a D-STATCOM should have a nonlinear and robust structure. In this study, a neuro-fuzzy controller (NFC), which is a robust and nonlinear controller, is proposed for dq-axis current control of a D-STATCOM. A DSP-based experimental setup is built for real-time control. The basic building block of the experimental setup is a three-level cascaded inverter. This inverter is constructed by using three IPM intelligent modules. A DS1103 controller card is used for real-time control of the D-STATCOM's experimental setup. The control algorithm is prepared in MATLAB/Simulink software and loaded to the DS1103 controller card. The performance of the NFC current-controlled D-STATCOM is tested for different load conditions: no load to full inductive, no load to full capacitive, full inductive to full capacitive, and full capacitive to full inductive. For this aim, the reactive current setpoint is changed as a step. The experimental results are presented to show the efficiency of the proposed controller under different load conditions.

show abstract

A multifunctional DSTATCOM for power quality improvement

Cited by 5 publications

References 19 publications

Enhancement of cascaded multi-level VSC STATCOM performance using ANN in the presence of faults

Enhancement of cascaded multi-level VSC STATCOM performance using ANN in the presence of faults

Enhancing the performance of cascaded three-level VSC STATCOM by ANN controller with SVPWM integegration

Real-time implementation of three-level inverter-based D-STATCOM using neuro-fuzzy controller

Contact Info

Product

Resources

About