A Configuration System for Real-Time Monitoring and Controlling Electricity Consumption Behavior

Susanti, Lusi; Fatrias, Dicky; Ichwana, Dody; Kamil, Husnil; Putri, Meylia Vivi

doi:10.1109/icitsi.2018.8696022

Cited by 6 publications

(1 citation statement)

References 4 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Waste in the consumption of electrical energy is often caused by negligence in turning off the light switch [1]. The automation on the lamp applied to provide energy efficiency [2].…”

Section: Introductionmentioning

confidence: 99%

Automated lighting design in the classroom

Widya Pratama,

Soehartanto,

Ari Wibowo

et al. 2024

Bulletin EEI

View full text Add to dashboard Cite

Lamp automation is utilized to adjust the lighting in the classroom by adjusting to the level of sunlight intensity outside the classroom. The light intensity will be adjusted to the utilization of lights as indicated by the need to enlighten a room. Therefore, this research aims to depict the design of a light intensity measurement system using a BH1750 sensor that will be carried out to measure the intensity of sunlight in units of light (lux). The signal from the sensor will be transmitted to a mini pc which functions to process measurement data and display it on the graphical user interface (GUI). As a result, the sensor will instruct the dimmer as an actuator to control the classroom lights according to the lighting from the sun. This system is already installed in the classroom and can save energy around 35 kWh a year.

show abstract

“…Waste in the consumption of electrical energy is often caused by negligence in turning off the light switch [1]. The automation on the lamp applied to provide energy efficiency [2].…”

Section: Introductionmentioning

confidence: 99%

Automated lighting design in the classroom

Widya Pratama,

Soehartanto,

Ari Wibowo

et al. 2024

Bulletin EEI

View full text Add to dashboard Cite

show abstract

Online monitoring and data logging power quality parameters of Low Voltage Distribution Panel (LVDP) on industrial system

Setiawan

Ronilaya

Aji

et al. 2020

IOP Conf. Ser.: Mater. Sci. Eng.

View full text Add to dashboard Cite

Electrical energy is an important component in an industry, that is needed by electrical equipment / machines that exist in the industry. Currently, the majority of electrical energy is produced from fossils, almost 85% of all energy comes from fossil fuels. Therefore, efficiency application of electricity loads in industries need to be logged and analyzed. To make electricity load efficiency possible, it can be done by monitoring and logging real-time electricity loads in the industry. So that, the electrical power consumed can be analyzed. In this paper, a 3-phase electricity monitoring system is builder for Low Voltage Power Distribution (LVDP) that can be monitored anytime and anywhere via internet for the needs of electricity quality analysis. Monitoring parameters are voltage, current, real power, apparent power, power factor, IHD voltage and current, and voltage and current THD for each phase. The system uses sensor ZMPT101B to get voltage value each phase and Current Transormator (CT) to get current value each phase. Then, that sensor value calculates with Arduino and raspberry pi. Arduino to calculate real power, apparent power, and power factor. Raspberry pi to calculate IHD voltage, current and THD voltage and current. That variables send to database and display on the web. Error reading of voltage sensor is found on average error 0.00254% compared to multimeter. For current sensor, the average error is 0.0074%. On the user interface, all functions are running well including the addition of devices, as well as monitoring parameters of each phase, so that, it can be utilized for the needs of electrical analysis, which means the power consumed and the malconsumed can be known.

show abstract