A 36-Pulse Diode-Bridge Rectifier Using Dual Passive Harmonic Reduction Methods at DC Link

Gao, Lei; Xu, Xianglian; Man, Zhongcheng; Lee, Junyuan

doi:10.1109/tpel.2018.2835511

Cited by 33 publications

(26 citation statements)

References 22 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In this paper, the flux density is taken as 0.8 T, and the current density is considered as 2.3 A/mm 2 . Noted that to minimize the current THD, it has been demonstrated in [35] and [38] that the secondary to primary turn ratio must be 10.74 and 5.06, respectively, but in the proposed IPT, this turn ratio is 21.48, which is in a good agreement with the results presented in Fig. 6.…”

Section: B Novel Pulse Tripling Circuit (Ptc)supporting

confidence: 87%

“…But, the proposed 36-PR, which is based on polygon autotransformer of this paper, has the rating of 24.16% of the load rating, which is 10.78% less than the one given in [35]. This means that it can be used for retrofit applications, which is not possible for the one presented in [35]. It must be mentioned that in [39], a 36-PR has been proposed, which is based on 12-pulse diode rectifier with two auxiliary singlephase full wave rectifiers (ASFRs).…”

Section: B Novel Pulse Tripling Circuit (Ptc)mentioning

confidence: 69%

“…6. However, the rating of the multitapped IPT used in [35], is 2.68% and that of the suggested IPT used in the proposed PTC is 1.57%. Also, the rating of this 36-PR based on star autotransformer [35] and star transformer [38] was approximately 48% and more than 100% of the load power, respectively.…”

Section: B Novel Pulse Tripling Circuit (Ptc)mentioning

confidence: 95%

“…However, the rating of the multitapped IPT used in [35], is 2.68% and that of the suggested IPT used in the proposed PTC is 1.57%. Also, the rating of this 36-PR based on star autotransformer [35] and star transformer [38] was approximately 48% and more than 100% of the load power, respectively. But, the proposed 36-PR, which is based on polygon autotransformer of this paper, has the rating of 24.16% of the load rating, which is 10.78% less than the one given in [35].…”

Section: B Novel Pulse Tripling Circuit (Ptc)mentioning

confidence: 95%

“…Also, the rating of this 36-PR based on star autotransformer [35] and star transformer [38] was approximately 48% and more than 100% of the load power, respectively. But, the proposed 36-PR, which is based on polygon autotransformer of this paper, has the rating of 24.16% of the load rating, which is 10.78% less than the one given in [35]. This means that it can be used for retrofit applications, which is not possible for the one presented in [35].…”

Section: B Novel Pulse Tripling Circuit (Ptc)mentioning

confidence: 99%

See 4 more Smart Citations

Pulse Tripling Circuit and Twelve Pulse Rectifier Combination for Sinusoidal Input Current

et al. 2021

View full text Add to dashboard Cite

In this paper, a novel pulse tripling circuit (PTC) is suggested, to upgrade a polygon autotransformer 12-pulse rectifier (12-PR) to a 36-pulse rectifier (36-PR) with a low power rating. The kVA rating of the proposed PTC is lower compared to the conventional one (about 1.57% of load power). Simulation and experimental test results show that the total harmonic distortion (THD) of the input current of the suggested 36-PR is less than 3%, which meets the IEEE 519 requirements. Also, it is shown that in comparison with other multi-pulse rectifiers (MPR), it is cost-effective, its power factor is near unity and its rating is about 24% of the load rating. Therefore, the proposed 36-PR can be considered as a practical solution for industrial applications.

show abstract

Section: B Novel Pulse Tripling Circuit (Ptc)supporting

confidence: 87%