A 250Mb/s-to-3.4Gb/s HDMI receiver with adaptive loop updating frequencies and an adaptive equalizer

Luo, Yi; Ping, Chen; Chen, Qui-Ting; Wang, Chih-Yong; Chang, Chan-Hao; Fu, Szu-Jui; Chen, Chien‐Ming; Li, Hung-Sung

doi:10.1109/isscc.2009.4977372

Cited by 5 publications

(1 citation statement)

References 2 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…If a transmitter sends clock signal together with serial data to a receiver like in High-Definition Multimedia Interface (HDMI), the role of CDR circuit is relatively simple because it does not need to track the frequency offset between the transmitter and the receiver [8]. If no clock is forwarded from a transmitter to a receiver like in PCI-Express (PCI-E), Serial-ATA (SATA), and Universal Serial Bus (USB), however, there can be non-zero frequency difference between the transmitter and the receiver clocks.…”

Section: Introductionmentioning

confidence: 99%

A 1.5–5.0 Gb/s clock and data recovery circuit with dual-PFD phase-rotating phase locked loop

Choi

Yoo

2014

IEICE Electron. Express

View full text Add to dashboard Cite

A clock and data recovery (CDR) circuit for 1.5-5.0 Gb/s wireline transceiver is described. A phase locked loop (PLL) with dual phase frequency detector (PFD) and charge pump (CP) pairs performs the seamless phase rotation for the CDR circuit to track the phase and frequency difference. The CDR circuit implemented in a 65 nm CMOS process consumes 22.8 mW from a 1.2 V supply at 5.0 Gb/s. For 25 MHz jitter frequency, the CDR circuit can tolerate up to 0.21 unit-interval (UI) jitter with bit error rate (BER) smaller than 10 !12 .

show abstract

Section: Introductionmentioning

confidence: 99%

A 1.5–5.0 Gb/s clock and data recovery circuit with dual-PFD phase-rotating phase locked loop

Choi

Yoo

2014

IEICE Electron. Express

View full text Add to dashboard Cite

show abstract

A 4Gb/s adaptive FFE/DFE receiver with data-dependent jitter measurement

Kim

Han

et al. 2011

2011 Proceedings of the ESSCIRC (ESSCIRC)

View full text Add to dashboard Cite

A digital wideband CDR with ±15.6kppm frequency tracking at 8Gb/s in 40nm CMOS

Pan

Valliappan

Zhang

et al. 2011

2011 IEEE International Solid-State Circuits Conference

View full text Add to dashboard Cite

It has been well understood that the digital clock and data recovery (CDR) architecture has many system merits over the analog counterpart for multi-Gb/s transceivers [1]. However, the applications have been limited in systems where the clock is forwarded or has small frequency offset [2,3], due to the finite frequency and jitter tracking capability of the digitally controlled phase rotation. Recently, tracking range up to ±7800ppm has been reported [4] to extend the applications to the SATA/SAS interfaces that require 5000ppm spread spectrum clocking (SSC) to suppress electromagnetic emissions. To enable broad acceptance in high-speed applications, the digital CDRs must have much wider tracking range.First, it is highly desirable to use an on-chip (CMOS) clock available at any frequency F ref as the reference for the fixed frequency PLL. This requires the CDR to track any fractional frequency offset within ±F ref assuming the integer feedback divider ratio N programmable at a step size of 2. The ratio ±F ref / F baud amounts to ±5kppm, given F ref in the low tens MHz range (e.g., 27MHz) and the data rate F baud in the multi-Gb/s range (e.g., 6Gb/s). Second, the CDR needs to be wideband to track out the low frequency jitter from the clock reference, the VCO, the power supply and other noise sources in the system. The jitter can be tens of unit intervals (UIs) as is specified by many sinusoidal jitter (SJ) tolerance masks that roll-off at 20dB/dec and settle to SJ min ~ 0.5UI at frequencies F SJ > F baud /1000. The SJ translates to a maximum frequency variation of ±(2πF baud /1000) × SJ min~ ±3000ppm. Finally, there is an increasing demand for ±5kppm and more SSC. The overall frequency tracking range spec is therefore ±5kppm (offset) ±3kppm (SJ) ±5kppm (SSC) = ±13kppm. This paper presents an 8Gb/s digital CDR that achieves a tracking range of ±15.6kppm and a tracking bandwidth up to 10MHz. Figure 25.4.1 shows the block diagram of a 1.25 to 8Gb/s SerDes transceiver in 40nm CMOS that incorporates the digital wideband CDR. Along with the adaptive peaking equalization, TX pre-emphasis, and SSC generation in the transceiver, the digital CDR supports applications such as SATA/SAS, USB3.0, PCIe, DisplayPort, EPON, etc. Special features such as the host tracking for HDD SATA and the loop timing for passive optical network (PON) applications are realized by looping the digital phase rotation signal from the CDR to the TX side phase interpolator (PI) through a programmable IIR filter without the need for a costly analog clean-up filter.The CDR performance is achieved through architecture optimization and circuit innovations. The first two architecture decisions are on the demux ratio and the resolution of phase rotation, which together determine the tracking range. Demultiplexing by 1-to-4 maximizes the speed without causing substantial latency overhead from pipelining the digital operations; a resolution of 32 phase steps is chosen as a result of trade-off between the quantization noise and the rotation speed. As is shown ...

show abstract

A 250Mb/s-to-3.4Gb/s HDMI receiver with adaptive loop updating frequencies and an adaptive equalizer

Cited by 5 publications

References 2 publications

A 1.5–5.0 Gb/s clock and data recovery circuit with dual-PFD phase-rotating phase locked loop

A 1.5–5.0 Gb/s clock and data recovery circuit with dual-PFD phase-rotating phase locked loop

A 4Gb/s adaptive FFE/DFE receiver with data-dependent jitter measurement

A digital wideband CDR with ±15.6kppm frequency tracking at 8Gb/s in 40nm CMOS

Contact Info

Product

Resources

About

A 250Mb/s-to-3.4Gb/s HDMI receiver with adaptive loop updating frequencies and an adaptive equalizer

Cited by 5 publications

References 2 publications

A 1.5–5.0 Gb/s clock and data recovery circuit with dual-PFD phase-rotating phase locked loop

A 1.5–5.0 Gb/s clock and data recovery circuit with dual-PFD phase-rotating phase locked loop

A 4Gb/s adaptive FFE/DFE receiver with data-dependent jitter measurement

A digital wideband CDR with &#x00B1;15.6kppm frequency tracking at 8Gb/s in 40nm CMOS

Contact Info

Product

Resources

About

A digital wideband CDR with ±15.6kppm frequency tracking at 8Gb/s in 40nm CMOS