Experiments were performed to study electron acceleration by intense sub-picosecond laser pulses propagating in sub-mm long plasmas of near critical electron density (NCD). Low density foam layers of 300-500 μm thickness were used as targets. In foams, the NCD-plasma was produced by a mechanism of super-sonic ionization when a well-defined separate ns-pulse was sent onto the foamtarget forerunning the relativistic main pulse. The application of sub-mm thick low density foam layers provided a substantial increase of the electron acceleration path in a NCD-plasma compared to the case of freely expanding plasmas created in the interaction of the ns-laser pulse with solid foils. The performed experiments on the electron heating by a 100 J, 750 fs short laser pulse of 2-5×10 19 W cm −2 intensity demonstrated that the effective temperature of supra-thermal electrons increased from 1.5-2 MeV in the case of the relativistic laser interaction with a metallic foil at high laser contrast up to 13 MeV for the laser shots onto the pre-ionized foam. The observed tendency towards a strong increase of the mean electron energy and the number of ultra-relativistic laseraccelerated electrons is reinforced by the results of gamma-yield measurements that showed a 1000fold increase of the measured doses. The experiment was supported by 3D-PIC and FLUKA simulations, which considered the laser parameters and the geometry of the experimental set-up. Both, measurements and simulations showed a high directionality of the acceleration process, since the strongest increase in the electron energy, charge and corresponding gamma-yield was observed close to the direction of the laser pulse propagation. The charge of super-ponderomotive electrons with energy above 30 MeV reached a very high value of 78 nC.

We report on enhanced laser driven electron beam generation in the multi MeV energy range that promises a tremendous increase of the diagnostic potential of high energy sub-PW and PW-class laser systems. In the experiment, an intense sub-picosecond laser pulse of ∼1019 Wcm−2 intensity propagates through a plasma of near critical electron density (NCD) and drives the direct laser acceleration (DLA) of plasma electrons. Low-density polymer foams were used for the production of hydrodynamically stable long-scale NCD-plasmas. Measurements show that relativistic electrons generated in the DLA-process propagate within a half angle of 1 2 ± 1° to the laser axis. Inside this divergence cone, an effective electron temperature of 10–13 MeV and a maximum of the electron energy of 100 MeV were reached. The high laser energy conversion efficiency into electrons with energies above 2 MeV achieved 23% with a total charge approaching 1 μC. For application purposes, we used the nuclear activation method to characterize the MeV bremsstrahlung spectrum produced in the interaction of the high-current relativistic electrons with high-Z samples and measured top yields of gamma-driven nuclear reactions. The optimization of the high-Z target geometry predicts an ultra-high MeV photon number of ∼1012 per shot at moderate relativistic laser intensity of 1019 Wcm−2. A good agreement between the experimental data and the results of the 3D-PIC and GEANT4-simulations was demonstrated.

Ultra-intense MeV photon and neutron beams are indispensable tools in many research fields such as nuclear, atomic and material science as well as in medical and biophysical applications. For applications in laboratory nuclear astrophysics, neutron fluxes in excess of 1021 n/(cm2 s) are required. Such ultra-high fluxes are unattainable with existing conventional reactor- and accelerator-based facilities. Currently discussed concepts for generating high-flux neutron beams are based on ultra-high power multi-petawatt lasers operating around 1023 W/cm2 intensities. Here, we present an efficient concept for generating γ and neutron beams based on enhanced production of direct laser-accelerated electrons in relativistic laser interactions with a long-scale near critical density plasma at 1019 W/cm2 intensity. Experimental insights in the laser-driven generation of ultra-intense, well-directed multi-MeV beams of photons more than 1012 ph/sr and an ultra-high intense neutron source with greater than 6 × 1010 neutrons per shot are presented. More than 1.4% laser-to-gamma conversion efficiency above 10 MeV and 0.05% laser-to-neutron conversion efficiency were recorded, already at moderate relativistic laser intensities and ps pulse duration. This approach promises a strong boost of the diagnostic potential of existing kJ PW laser systems used for Inertial Confinement Fusion (ICF) research.

This paper presents an analysis of laser-plasma interaction risks of the shock ignition (SI) scheme and experimental results under conditions relevant to the corona of a compressed target. Experiments are performed on the LIL facility at the 10 kJ level, on the LULI 2000 facility with two beams at the kJ level and on the LULI 6-beam facility with 100 J in each beam. Different aspects of the interaction of the SI pulse are studied exploiting either the flexibility of the LULI 6-beam facility to produce a very high intensity pulse or the high energy of the LIL to produce long and hot plasmas. A continuity is found allowing us to draw some conclusions regarding the coupling quality and efficiency of the SI spike pulse. It is shown that the propagation of the SI beams in the underdense plasma present in the corona of inertial confinement fusion targets could strongly modify the initial spot size of the beam through filamentation. Detailed experimental studies of the growth and saturation of backscattering instabilities in these plasmas indicate that significant levels of stimulated scattering reflectivities (larger than 40%) may be reached at least for some time during the SI pulse.

The interaction of a high-power laser with a low-density foam target can in some instances result in a significant enhancement in x-ray generation relative to that when the same laser is incident upon a homogenous solid. In this paper, we present x-ray emission studies from foam targets where the density is varied from under-dense to over-dense. The targets are irradiated with the first harmonic of Nd:Glass laser. The laser intensity on the target was approximately 2 × 1014 W/cm2 with the pulse duration of 500 ps. Mass-matched cellulose triacetate foam targets with densities of 2 mg/cc, 4 mg/cc, 7 mg/cc, and 20 mg/cc were used. The areal density presented by the targets on the laser beam axis was held constant at 0.2 mg/cm2 by varying the target thickness in inverse proportion to the density. The x-ray yield in the spectral range (5–8 keV) and (4.5–16 keV) was found to be enhanced by approximately 2.3 times in foam targets with the density of 2 mg/cc (under-dense) compared with foam targets with the density of 20 mg/cc (over-dense).