a b s t r a c tThree-dimensional numerical simulations of Berkovich, Vickers and conical indenter hardness tests were carried out to investigate the influence of indenter geometry on indentation test results of bulk and composite film/substrate materials. The strain distributions obtained from the three indenters tested were studied, in order to clarify the differences in the load-indentation depth curves and hardness values of both types of materials. For bulk materials, the differentiation between the results obtained with the three indenters is material sensitive. The indenter geometry shape factor, b, for evaluating Young's modulus for each indenter, was also estimated. Depending on the indenter geometry, distinct mechanical behaviours are observed for composite materials, which are related to the size of the indentation region in the film. The indentation depth at which the substrate starts to deform plastically is sensitive to indenter geometry.

The main difficulty with the characterization of thin coatings using depth-sensing indentation tests is related to the determination of the contributions of the substrate and the film to the measured properties. In this study, three-dimensional numerical simulations of the Vickers hardness test are used in order to examine the influence of the elastic and plastic properties of the substrate and the film on the composite's Young's modulus results. The hardness of the film is equal to or higher than the substrate hardness. A study of the stress distributions and the indentation geometry of composites, film/ substrate, was performed, taking into account the relative mechanical properties of the film and substrate. In addition, stress evolution during indentation was studied, in order to quantify the critical indentation depth under which the substrate is not elastically deformed. The accurate evaluation of the Young's modulus of the films using weight functions is also examined: some of these have previously been proposed and one was introduced for this study. Two different fitting procedures were used to compare the results obtained from eight fictive film/substrate combinations using six weight functions. The first procedure, commonly used, considers the substrate's modulus as a known parameter in the fitting process. In the second, the film and the substrate's modulus are considered as unknown variables that are calculated simultaneously during the fitting process. The validity of the conclusions obtained using the fictive materials was checked by applying the weight functions to four real composites.

No abstract

The elastic properties of chiral and non-chiral single-walled boron nitride nanotubes in a wide range of their chiral indices and diameters were studied. With this aim, a three-dimensional finite element model was used to assess their rigidities and, subsequently, elastic moduli and Poisson’s ratio. An extensive study was performed to understand the impact of the input parameters on the results obtained by numerical simulation. For comparison, the elastic properties of single-walled boron nitride nanotubes are shown together with those obtained for single-walled carbon nanotubes.

This article is a review regarding recently developed inverse strategies coupled with finite element simulations for the identification of the parameters of constitutive laws that describe the plastic behaviour of metal sheets. It highlights that the identification procedure is dictated by the loading conditions, the geometry of the sample, the type of experimental results selected for the analysis, the cost function, and optimization algorithm used. Also, the type of constitutive law (isotropic and/or kinematic hardening laws and/or anisotropic yield criterion), whose parameters are intended to be identified, affects the whole identification procedure.