The deformation behavior of duplex stainless steel under tension and bending, accompanied by a pulsed current and when heated by an external source, is investigated. The stress–strain curves are compared at the same temperatures. The contribution to the decrease in flow stresses is greater when using a multi-pulse current at the same temperature, compared to external heating. This confirms the presence of an electroplastic effect. An increase in the strain rate by an order of magnitude reduces the contribution of the electroplastic effect from single pulses to the reduction in flow stresses by 20%. An increase in the strain rate by an order of magnitude reduces the contribution of the electroplastic effect from single pulses to the reduction in flow stresses by 20%. However, in the case of a multi-pulse current, the strain rate effect is not observed. Introducing a multi-pulse current during bending reduces the bending strength by a factor of two and the springback angle to 6.5.
В статье исследовано влияние импульсного тока высокой плотности на деформационное поведение титана с различной дисперсностью структуры. Проведено сравнение особенностей деформационных кривых крупнозернистого и наноструктурированного технически чистого титана Grade 4 при растяжении с введением импульсного тока. Ток различной скважности и плотности от импульсного генератора подводили к образцу, находящемуся в захватах разрывной машины. Микроструктуру образцов крупнозернистого титана в головке образца и вблизи области разрушения в продольном сечении исследовали методом оптической микроскопии. Для исследования микроструктуры фольг наноструктурированного титана использовали метод просвечивающей электронной микроскопии. Электропластический эффект в исследованных материалах проявлялся на кривой растяжения в виде отдельных скачков напряжения вниз. При одинаковых режимах импульсного тока высокой скважности амплитуда скачков напряжения в крупнозернистом титане выше, чем в наноструктурном титане. Для тока низкой скважности скачки напряжения одинаковы в пластической области. Импульсный ток высокой скважности в наноструктурированном титане приводил к аномальному эффекту упрочнения, физическая природа которого нуждается в дополнительном исследовании. Использованные режимы импульсного тока не привели к заметным при оптическом увеличении структурным изменениям растягиваемых образцов, кроме исчезновения двойников и выделения частиц примесей в крупнозернистом титане. Фрактографические картины разрушения наноструктурированного титана, деформированного с током и без тока свидетельствуют о вязком разрушении без существенных изменений, что свидетельствует о минимальном тепловом вкладе в процессе экспериментов. The influence of a high-density pulsed current on the deformation behavior of titanium with different structure refinement is studied. A comparison of the features of the deformation curves has been carried out of coarse-grained and nanostructured commercial pure Ti Grade 4 under tension with the introduction of a pulsed current. A current of various duty ratio and densities was supplied from a pulse generator to a sample in the grips of a tensile testing machine. The microstructure of a coarsegrained titanium in the sample head and near the fracture region in the longitudinal section was studied by optical microscopy. To study the microstructure of nanostructured titanium foils, the transmission electron microscopy was used. The electroplastic effect in the studied materials manifested itself in the tensile curve in the form of separate downward stress jumps. Under the same regimes of high-duty ratio pulsed current, the amplitude of stress jumps in the coarse-grained titanium is higher than in the nanostructured titanium. For a low duty ratio current the stress jumps are the same in the plastic region. A high duty ratio pulsed current in nanostructured titanium led to an anomalous hardening effect, the physical nature of which needs a further investigation. The used modes of the pulsed current did not lead to structural changes noticeable under optical magnification of the tensile samples, except for the disappearance of twins and the separation of impurity particles in the coarse-grained titanium. The fractographic fracture patterns of nanostructured titanium tested with and without current indicate ductile fracture without significant changes, which testified a minimal thermal contribution during the experiments.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.