При проектировании современных локационных комплексов помимо поиска крупных летательных аппаратов типа самолетов или вертолетов также возникает задача быстрого обнаружения малоразмерных воздушных объектов, что в свою очередь вынуждает разработчиков данных систем применять в их составе лазерные источники для зондирования воздушного пространства. Целью работы является исследование возможности применения источников лазерного излучения для локации малоразмерных объектов, а также требований к лазерным локационным системам и проблем, связанных с переходом от радиоволнового диапазона к оптическому. В работе рассмотрены проблема обнаружения малоразмерных воздушных объектов и связанный с ней вопрос построения лазерных локационных систем кругового обзора. Описаны методы определения расстояний до объектов и измерения их угловых координат, которые применяются в данных системах. Приведен предполагаемый состав разрабатываемой системы и отмечены основные функции ее частей, а также их взаимодействие. Представлены оценка необходимой мощности лазерного излучения и количество применяемых в системе лазерных источников в зависимости от предельной дальности зондирования. Предложен способ решения поставленной проблемы за счет разделения системы на блок определения угловых координат и блок определения дальности.Работа выполнена в рамках темы НИР УдмФИЦ УрО РАН «Искусственный интеллект в разработке, обучении и сопровождении экспертных систем представления и использования знаний в естественно-научных, технических и социогуманитарных направлениях» АААА-А19-119092690104-4.
At the present time, developing of autonomous laser systems requires increasing of the output power of the laser sources used in composition of those systems and at the same time reducing of the energy usage in the system. The possibility of increasing output peak power of pulsed laser sources by using the method of synchronous non-coherent beam combining in ring fiber-optic delay line is considered by authors. Objective of this work was estimating energy effectiveness of laser systems, which based on this method.General constructing method of the laser pulsed laser source with ring fiber delay line is considered, its block diagram and the general operating principle of similar systems are presented. Two versions of laser systems based on the described method of beam combining are presented: using an optical combiner and an optical switch; using fiber welding instead of a combiner and an optical switch. The graphical dependence of the energy effectiveness on the number of circulations in ring fiber-optic delay line is obtained for both versions of laser systems.As a result of the analysis of the considered devices operation, it was shown that considered systems allow to obtain increasing the peak power of a laser pulse without increasing the power supply, also the system, that use welded fi instead of the optical combiner, has greater effi than system with optical combiner.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.