This work is aimed at using the technogenic raw materials of the Kovdorsky GOK for the production of refractory materials. Currently, many researchers are engaged in the development of technologies for unshaped materials. The most demanded among them are refractory concrete. They are able to set and harden at low temperatures with the formation of structures that retain their characteristics when heated. In our work, concretes were obtained from a briquette based on forsterite concentrate obtained from the waste of the Kovdorsky GOK. Magnesium phosphate cement was used as a binder. As a result of the research, the grain composition of the charge was selected, the ratio of filler and binder to improve the structural properties of concrete was found, the effects of the composition and the temperature of heat treatment of concretes on the physical and technical properties were shown. Concretes have the following characteristics: bulk density 2170-2260 kg / m 3 , strength up to 50 MPa (at 25°C), volume change after heat treatment at 450-1000°C 1-2%. Recovering the waste of the Kovdorsky GOK by manufacture of concrete will lead to a qualitatively new use of non-renewable natural resources, reduce the rate of depletion of mineral raw materials in the subsoil, eliminate sources of environmental pollution and restore land occupied by waste.
Аннотация. Основное направление по совершенствованию производства огнеупоров-развитие технологии неформованных материалов. Наиболее востребованными являются огнеупорные бетоны. Они способны схватываться и твердеть при низких температурах с образованием структур, сохраняющих свои характеристики при нагревании. В этом исследовании бетоны были получены из брикета на основе форстеритового концентрата из отходов Ковдорского горно-обогатительного комбината и связующего фосфата магния. В результате был выбран зерновой состав шихты, найдено соотношение заполнителя и связующего для улучшения структурных свойств бетона; выявлено влияние состава и температуры термообработки брикета на физико-технические свойства полученных материалов. Бетоны обладают следующими характеристиками: плотность 2170-2260 кг/м 3 , прочность-до 49 МПа (при 25 ° С), изменение объема после термообработки при 450-1000 ° С составляет 1-2 %. Ключевые слова: неформованный материал, форстеритовый концентрат, магнийфосфатная связка, огнеупорный бетон.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.