We performed Raman studies and a dielectric characterization of the pseudo-kagome Cu 3 Bi(SeO 3 ) 2 O 2 X (X = Cl, Br). These compounds share competing nearest-neighbour ferromagnetic exchange and frustrating next-nearest-neighbour antiferromagnetic exchange as well as highly noncollinear magnetic ground state. However, at low temperature they differ with respect to the existence of inversion symmetry. For both compounds there exists a pronounced interplay of polar phonon modes with quantum magnetic fluctuations. A novel Raman mode appears for temperatures below the Neel temperature with a Fano lineshape and an enormous intensity that exceeds most of the phonon lines. We discuss a possible contribution of longitudinal magnons to this signal. In contrast, one magnon scattering based on linear transvers magnons is excluded based on a symmetry analysis of spin wave representations and Raman tensor calculations. There exists evidence that in these pseudo-kagome compounds magnetic quantum fluctuations carry an electric dipole moment. Our data as well as a comparison with previous farinfrared spectra allow us to conclude that Cu 3 Bi(SeO 3 ) 2 O 2 Cl changes its symmetry most likely from Pmmn to P2 1 mn with a second order structural phase transition at T*=120 K and becomes multiferroic. Cu 3 Bi(SeO 3 ) 2 O 2 Br represents an interesting counter part as it does not show this instability and stays inversion symmetric down to lowest temperatures, investigated.PACS:

We report the synthesis and characterization of the new bismuth iron selenite oxochloride Bi2Fe(SeO3)2OCl3. The main feature of its crystal structure is the presence of a reasonably isolated set of spin S = 5/2 zigzag chains of corner-sharing FeO6 octahedra decorated with BiO4Cl3, BiO3Cl3, and SeO3 groups. When the temperature is lowered, the magnetization passes through a broad maximum at Tmax ≈ 130 K, which indicates the formation of a magnetic short-range correlation regime. The same behavior is demonstrated by the integral electron spin resonance intensity. The absorption is characterized by the isotropic effective factor g ≈ 2 typical for high-spin Fe(3+) ions. The broadening of ESR absorption lines at low temperatures with the critical exponent β = 7/4 is consistent with the divergence of the temperature-dependent correlation length expected for the quasi-one-dimensional antiferromagnetic spin chain upon approaching the long-range ordering transition from above. At TN = 13 K, Bi2Fe(SeO3)2OCl3 exhibits a transition into an antiferromagnetically ordered state, evidenced in the magnetization, specific heat, and Mössbauer spectra. At T < TN, the (57)Fe Mössbauer spectra reveal a low saturated value of the hyperfine field Hhf ≈ 44 T, which indicates a quantum spin reduction of spin-only magnetic moment ΔS/S ≈ 20%. The determination of exchange interaction parameters using first-principles calculations validates the quasi-one-dimensional nature of magnetism in this compound.

No abstract

Fe 3+ S = 5/2 ions form saw-tooth like chains along the a axis of the oxo-selenite Fe2O(SeO3)2 and an onset of long-range magnetic order is observed for temperatures below TC = 105 K. This order leads to distinct fingerprints in phonon mode linewidths and energies as resolved by Raman scattering. In addition, new excitations with small linewidths emerge below T = 150 K, and are assigned to two-magnon scattering processes with the participation of flat-band and high energy magnon branches. From this a set of exchange coupling constants is estimated. The specific ratio of the saw-tooth spine-spine and spine-vertex interactions may explain the instability of the dimer quantum ground state against an incommensurate 3D magnetic order. arXiv:1901.09617v1 [cond-mat.str-el]

Development of biocompatible 3D scaffolds is one of the most important challenges in tissue engineering. In this study, we developed polymer scaffolds of different design and microstructure to study cell growth in them. To obtain scaffolds of various microstructure, e.g., size of pores, we used double- and one-stage leaching methods using porogens with selected size of crystals. A composite of poly(3-hydroxybutyrate) (PHB) with poly(ethylene glycol) (PEG) (PHB/PEG) was used as polymer biomaterial for scaffolds. The morphology of scaffolds was analyzed by scanning electron microscopy; the Young modulus of scaffolds was measured by rheometry. The ability to support growth of mesenchymal stem cells (MSCs) in scaffolds was studied using the XTT assay; the phenotype of MSC was preliminarily confirmed by flow cytometry and the activity of alkaline phosphatase and expression level of CD45 marker was studied to test possible MSC osteogenic differentiation. The obtained scaffolds had different microstructure: the scaffolds with uniform pore size of about 125 µm (normal pores) and 45 µm (small pores) and scaffolds with broadly distributed pores size from about 50-100 µm. It was shown that PHB/PEG scaffolds with uniform pores of normal size did not support MSCs growth probably due to their marked spontaneous osteogenic differentiation in these scaffolds, whereas PHB/PEG scaffolds with diverse pore size promoted stem cells growth that was not accompanied by pronounced differentiation. In scaffolds with small pores (about 45 µm), the growth of MSC was the lowest and cell growth suppression was only partially related to stem cells differentiation. Thus, apparently, the broadly distributed pore size of PHB/PEG scaffolds promoted MSC growth in them, whereas uniform size of scaffold pores stimulated MSC osteogenic differentiation.