*Феоктистов А.В., к.т.н., доцент (umu@sibsiu.ru ) Модзелевская О.Г., старший преподаватель Бедарев С.А., к.т.н., доцент Сибирский государственный индустриальный университет (654007, Россия, Кемеровская обл., г. Новокузнецк, ул. Кирова, 42) Аннотация. Приведены расчетные данные об относительной прочности твердого топлива для различных соотношений содержаний кокса и антрацита в топливных колошах при испытаниях на установке определения прочности твердого топлива по разработанной методике. Ре-комендовано оптимальное, экспериментально обоснованное соотношение содержаний антрацита и кокса в топливных колошах (60 и 40 % соответственно при относительной прочности 0,85).Ключевые слова: вагранка, кокс, антрацит, относительная прочность, твердое топливо.Для определения оптимальных соотношений содер-жаний различных видов топлива в топливных колошах и обеспечения устойчивой работы ваграночных ком-плексов требуется критериальное обоснование соотно-шений содержаний антрацита и кокса и сравнение их с эталонными показателями.Для этого была проведена серия экспериментов на установке определения прочности твердого топлива, которая воспроизводит условия в период плавки в шах-те печи с различным содержанием кокса и антрацита в топливных колошах. Подробная схема и принцип дейст вия установки описаны в работах [1, 2] и защи-щены патентами РФ на полезные модели [№№ 96963, 99616, 106953, 102386].Эксперименты с помощью установки проводили в такой последовательности: загружали в установку топ ливо массой М 0 , устанавливали на засыпку расчет-ное количество грузов в виде металлических дисков. Через окно разжигали топливо, включали вентилятор для подачи воздуха на горение, фиксировали высоту осевшего в результате горения топлива (в момент, ког-да выгорает половина первоначальной навески топлива ΔМ = 0,5М 0 ); затем рассчитали разницу между перво-начальной высотой слоя (h 0 ) и высотой слоя после про-ведения опыта (h 1 ):(До момента измерения параметра Δh отключали вентилятор, после чего открывали шибер; остатки топ-лива высыпались в тару для определения конечной мас-сы М 1 . На рисунке показана схема к расчету критериев прочности топлива.Относительная прочность топлива при горении под нагрузкой P определяется по формулеОтносительная прочность, зависящая от разруше-ния и газификации топлива, определяется выражениемНачальная М 0 и конечная М 1 массы засыпки топлива в установку определяются формуламиСхема к расчету относительной прочности топлива * Работа выполнена согласно заданию № 2014/213 на выполне-ние государственных работ в сфере научной деятельности в рамках базовой части государственного задания Минобрнауки России. 38И з в е с т И я в ы с ш И х у ч е б н ы х з а в е д е н И й . чер н а я м е та л л у р г И я . 2014. то м 57. № 12 где ρ 0 и ρ 1 -насыпная плотность топлива до и после опыта, кг/м 3 ; S 0 - площадь сечения установки, м 2 . Из выражений (4) следует (5) Под нагрузкой куски топлива растрескиваются, осо-бенно интенсивно в период горения, образуется много мелочи, которая заполняет пустоты между крупными кусками. При э...
Аннотация. Проведен термогравиметрический анализ на дериватографе фирмы Setaram образцов литейного кокса и антрацита методом разбавления навески в порошкообразном термоинертном растворителе. Показана применимость метода для сравнительной оценки свойств различных углеродистых материалов. В процессе нагревания до 1500 °С поведение кокса и антрацита отличается незначительно, что свидетельствует о возможности замены кокса антрацитом. Образование расплава зольных остатков и их кристаллизация при последующем охлаждении зависит от количества и состава золы и может существенно влиять на ход технологического процесса.
8. К у д р я в ц е в а Л.Н., П е р е в е р з е в а Е.Г., Д е м а к ов а А.В. // Металловедение и термообработка металлов. 1969. № 6. С. 184-195. 9. Х а р л а ш и н П.С., Ш у м и л о в М.А., Я к у ш е ч к и н Е.И. Влияние мышьяка на свойства металлических систем и качество стали. − К.: Вища школа, 1991.-343 с. 10. Ш у м и л о в М.А., Куд р я в ц е в а Л.Н., М а т в и е н ко Л.В., А в р а м о в а З.В. // Изв. АН СССР. Металлы. 1984. № 5. С. 104-108.
Сибирский государственный индустриальный университет (654007, Россия, Новокузнецк, Кемеровская обл., Кирова, 42) Аннотация. Рассмотрены вопросы переноса и адекватности результатов плавки, полученных на вагранках малого диаметра, на вагранки промышленного назначения. Проведен анализ условий подобия при переходе от вагранок малого диаметра к вагранкам большего диаметра, который показал, что основные требования натурного (физического) моделирования выполняются. Сделан вывод, что температурный режим в холостой колоше и в зоне нагрева шихты не зависит от диаметра печи при условии выполнения полученных в работе основных соотношений между геометрическими параметрами печи, размерами кусков кокса и шихты, вытекающих из главных требований (теорем) теории подобия и натурного моделирования. Ключевые слова: вагранка, моделирование, подобие, геометрические параметры печи, шихта, кокс. * Работа выполнена согласно заданию № 2014/213 на выполнение государственных работ в сфере научной деятельности в рамках базовой части государственного задания Минобрнауки России.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.