Применение фокусаторов излучения для создания металлических нанопористых… Мурзин С.П. и др.
226Компьютерная оптика, 2013, том 37, №2 Аннотация Лазерным воздействием с применением фокусаторов излучения создан металлический нанопористый материал с высокой удельной площадью поверхности. Определены режимы лазерного воздействия, при котором в центре зоны термического влияния на поверхности исследуемого материала образуется нанопористый слой, содержащий продукты взаимодей-ствия с окислительной средой меди и цинка в составе сплава. Для оценки механической прочности и термостойкости полученного нанопористого материала образцы из латуни Л62 после лазерной обработки подвергали пластической деформации и высокотемпературному воздействию. Основная часть поверхности после пластической деформации по двум раз-личным режимам и двух высокотемпературных отжигов не имеет разрушений, отслаивания пористого слоя не наблюдалось, что свидетельствует о достаточно высокой механической прочности и термостойкости полученного нанопористого материала.Ключевые слова: воздействие лазерное, материал металлический, слой нанопористый, поверхность.
Conditions of pulse-periodic laser action with thermocycling for formation of a nanoporous structure consisting of principally channel-type nanosize pores in two-component Cu-Zn alloy “brass of 62%” are experimentally defined. The transformation of laser radiation into a light spot with uniform distribution of power density was carried out with the aid of an optical system containing an element of diffractive computer optics – radiation focusator. Depth and area locality of the physical processes in heat-affected zone with preservation of initial material properties and absence of significant deformation in the remaining volume is ensured in the implementation of the chosen conditions. The amount of structural defects – vacancies, dislocations and their clusters increases in two-component brass under the influence of thermal stress. Wedge-shaped submicrocavities that converge at their edges with formation of extensive nanosize channels with widths not more than 100 nm are formed in the material of 0.05 mm thickness.
669.715:620.186.5 The study of primary recrystallization processes in deformable aluminum alloys that have not been hardened by heat treatment makes possible a substantiated choice of technological conditions for pressure shaping. The data from metallographic analysis of the primary recrystallization of alloy 1570 are inadequate in comparison with the data for its industrial analog, alloy AMg6. In view of this we studied the distinctive features of primary recrystallization in semi-finished alloy 1570 strip.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.