No abstract

Erosion and deposition were studied in the JET divertor during the first JET ITER-like wall campaign 2011-2012 using marker tiles. An almost complete poloidal section consisting of tiles 0, 1, 3, 4, 6, 7, 8 was studied. The data from divertor tile surfaces were completed by the analysis of samples from remote divertor areas and from the inner wall cladding. The total mass of material deposited in the divertor decreased by a factor of 4-9 compared to the deposition of carbon during all-carbon JET operation before 2010. Deposits in 2011-2012 consist mainly of beryllium with 5-20 at.% of carbon and oxygen, respectively, and small amounts of Ni, Cr, Fe and W. This decrease of material deposition in the divertor is accompanied by a decrease of total deuterium retention inside the JET vessel by a factor of 10-20. The detailed erosion/deposition pattern in the divertor with the ITER-like wall 2 configuration shows rigorous changes compared to the pattern with the all-carbon JET configuration.

Deuterium (D) interaction with vacancies in tungsten (W) was studied using thermal desorption spectroscopy (TDS). In order to obtain a TDS spectrum with a prominent peak corresponding to D release from vacancies, a special procedure comprising damaging of a recrystallized W sample by low fluences of 10 keV/D ions, its annealing, and subsequent lowenergy ion implantation, was utilized. This experimental sequence was performed several times in series; the only difference was the TDS heating rate that varied in the range of 0.15-4 K/s. The sum of the D binding energy (E b) with vacancies and the activation energy for D diffusion (E D

No abstract

No abstract