Polyvinylpyrrolidone (PVP) and poly(ethylene glycol) (PEG) solid dispersion systems with flavanone glycosides, naringin and hesperidin, and their aglycones, naringenin and hesperetin, were prepared, using solvent evaporation method, to enhance their dissolution rates that may affect their bioavailability. Drug release of both flavanone glycosides and their aglycones was directly affected by the physical state of solid dispersions. Powder-XRD technique in combination with scanning and transmission electron microscopy revealed that PVP polymer formed amorphous nanodispersion systems with flavanone aglycones, while such systems could not be formed with their glycosides, which are bulkier molecules. Fourier transform infrared spectra suggest the presence of hydrogen bonds between PVP carbonyl groups and hydroxyl groups of both flavanone aglycones. These interactions prevent the crystallization of naringenin and hesperetin aglycones in PVP matrix. On the other hand, the ability of PEG carrier to form hydrogen bonds with flavanone glycosides or aglycones was limited, and as a result both flavanone glycosides and their aglycones remain in the crystalline form. For this reason, the solubility enhancement of PEG solid dispersions was lower than when PVP was used as drug carrier. At pH 6.8, the % release of naringenin and hesperetin from PVP/naringeninhesperetin (80/20 w/w) solid dispersion was 100% while in PEG solid dispersions, it was not higher than 60 -70%.
The physical structure and polymorphism of nimodipine were studied by means of micro-Raman, WAXD, DSC, and SEM for cases of the pure drug and its solid dispersions in PEG 4000, prepared by both the hot-melt and solvent evaporation methods. The dissolution rates of nimodipine/PEG 4000 solid dispersions were also measured and discussed in terms of their physicochemical characteristics. MicroRaman and WAXD revealed a signifi cant amorphous portion of the drug in the samples prepared by the hot-melt method, and that saturation resulted in local crystallization of nimodipine forming, almost exclusively, modifi cation I crystals (racemic compound). On the other hand, mainly modifi cation II crystals (conglomerate) were observed in the solid dispersions prepared by the solvent evaporation method. However, in general, both drug forms may appear in the solid dispersions. SEM and HSM microscopy studies indicated that the drug particle size increased with drug content. The dissolution rates were substantially improved for nimodipine from its solid dispersions compared with the pure drug or physical mixtures. Among solid dispersions, those resulting from solvent coevaporation exhibited a little faster drug release at drug concentrations lower than 20 wt%. Drug amorphization is the main reason for this behavior. At higher drug content the dissolution rates became lower compared with the samples from melt, due to the drug crystallization in modifi cation II, which results in higher crystallinity and increased particle size. Overall, the best results were found for low drug content, for which lower drug crystallinity and smaller particle size were observed.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.