At present, the flange drawing part with bottom hole is produced by at least 2 sets of dies and not qualifies for modern manufacture concept. In this paper, a compound die is designed which the flange drawing part can be blanked, drew, punched and trimmed in the same forming-position. The die is made of tow convex and concave dies, one drawing female die, one punching die, one blanking female die and one trimming punch. One of the convex and concave is used to blanking, the blank is drew by drawing female die and the other convex and concave, the punching die is applied to punch the bottom hole, the edge of blank is cut by trimming punch. Beside, the key design points and working process of the compound die were discussed as well.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.