Background. Diode lasers (DLs) have demonstrated equal or better desensitizing effects than fluoride varnish, 10% potas-sium nitrate (NK) gel and Gluma. The current study evaluated the desensitizing effect of combined application of DLs with two different output powers and compared it with single DL therapy.
Methods. Sixty-two hypersensitive teeth were allocated randomly into two groups: the single group was treated with 3-W DL beam once and in the combined group, the teeth were irradiated three times (the first time with 0.2-W and then with 3-W and the second and third times, 48 and 96 hours after the baseline visit, with 0.2-W DL beams). The amount of dentin hyper-sensitivity (DH) was evaluated, immediately before and after each visit, and 1 week and 1 and 3 months after the first visit. Data analysis was performed using chi-squared test, repeated measurement of ANOVA and Mann-Whitney U test. P<0.05 was considered statistically significant.
Results. Statistically significant changes were observed in the means of VAS indices between all the measurement intervals and pretreatment measures, in both experimental groups (P<0.001). The difference in VAS reduction among the groups was not significant when the hypersensitive teeth were stimulated by a periodontal probe and a jet of air (P=0.63 and P=0.12).
Conclusion. The results of the present study showed that using both high-intensity and combined DL beams gives rise to significant reductions in DH. There was no significant difference between combined and single laser therapies in the treatment of tooth hypersensitivity.
Objective: To determine the retentive force of three glass-ionomer luting cements used with prefabricated primary zirconium crowns (PPZCs) and to assess whether the retentive force was dependent on cementation material or different PPZCs brands. Study design: Four mandibular right second molar PPZCs were selected, one each from four manufacturers–NuSmile®ZR, Sprig Crowns, Cheng Crowns and Kinder Krowns. Silicone impressions of the outer surface of crowns were taken; stone dies prepared and reduced to fit the corresponding brand. 24 alginate impressions of each die obtained and filled with core buildup flowable composite. 96 composite tooth-replicas thus achieved were divided into four groups and further categorized into three subgroups of eight samples based on luting cements used – BioCem, FujiCEM®2 and KetacCem. Samples were thermocycled, placed in artificial saliva for one week followed by assessment of retentive force for crown dislodgment and failure mode. Results: Data was statistically evaluated using two-way ANOVA, HSD (P <0.05). KetacCem had the lowest retentive force while BioCem showed comparatively higher value to FujiCEM®2. Adhesive failure modes were predominant with cement mainly adhering to crown’s internal surface. Conclusions: Resin-based GI cements offered superior retention than conventional GI cements for PPZCs and retentive force was dependent on cement type.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.