Aqueous Zn batteries have drawn tremendous attention for their several advantages. However, the challenges of Zn anodes such as the corrosion and ZnO densification have compromised their application in rechargeable Zn‐based batteries. In this paper, a straightforward strategy is employed to facilitate the uniform Zn stripping/plating of the Zn anode through using a ZrO2 coating layer, which contributes to the controllable nucleation sites for Zn2+ and fast Zn2+ transportation through the favorable Maxwell–Wagner polarization. As a result, the low polarization (24 mV at 0.25 mA cm−2), high Coulombic efficiency (99.36% at 20 mA cm−2), and long cycle life (over 3800 h at 0.25 mA cm−2) can be obtained for the ZrO2‐coated Zn anode. It is believed that the ZrO2 coating layer can also act as an inert physical barrier to decrease the contact of the anode and electrolyte, thus reducing both the Zn corrosion and formation of ZnO densification, and then improve the reversibility of Zn anode. The results demonstrated in this work provide an appealing strategy for the future development of rechargeable Zn‐based batteries.

The band gaps of many atomically thin 2D layered materials such as graphene, black phosphorus, monolayer semiconducting transition metal dichalcogenides and hBN range from 0 to 6 eV. These isolated atomic planes can be reassembled into hybrid heterostructures made layer by layer in a precisely chosen sequence. Thus, the electronic properties of 2D materials can be engineered by van der Waals stacking, and the interlayer coupling can be tuned, which opens up avenues for creating new material systems with rich functionalities and novel physical properties. Early studies suggest that van der Waals stacked 2D materials work exceptionally well, dramatically enriching the optoelectronics applications of 2D materials. Here we review recent progress in van der Waals stacked 2D materials, and discuss their potential applications in optoelectronics. RECEIVED

The focus of this study was to demonstrate that, in the luminescent sensors, the signal transduction may possibly be the most important part in the sensing process. Rational design of fluorescent sensor arrays for cations utilizing extended conjugated chromophores attached to 8-hydroxyquinoline is reported. All of the optical sensors utilized in the arrays comprise the same 8-hydroxyquinoline (8-HQ) receptor and various conjugated chromophores to yield a different response to various metal cations. This is because the conjugated chromophores attached to the receptor are partially quenched in their resting state, and upon the cation coordination by the 8-HQ, the resulting metalloquinolinolate complex displays a change in fluorescence. A delicate balance of conjugation, fluorescence enhancement, energy transfer, and a heavy metal quenching effect results in a fingerprint-like pattern of responses for each sensor-cation complex. Principal component analysis (PCA) and linear discriminant analysis (LDA) are used to demonstrate the contribution of individual sensors within the array, information that may be used to design sensor arrays with the smallest number of sensor elements. This approach allows discriminating between 10 cations by as few as two or even one sensor element. Examples of arrays comprising various numbers of sensor elements and their utility in qualitative identification of Ca(2+), Mg(2+), Cd(2+), Hg(2+), Co(2+), Zn(2+), Cu(2+), Ni(2+), Al(3+), and Ga(3+) ions are presented. A two-member array was found to identify 11 analytes with 100% accuracy. Also the best two of the sensors were tested alone and both were found to be able to discriminate among the samples with 99% and 96% accuracy, respectively. To illustrate the utility of this approach to a real-world application, identification of enhanced soft drinks based on their Ca(2+), Mg(2+), and Zn(2+) cation content was performed. The same approach to reducing array elements was used to construct three- and two-member arrays capable of identifying these complex analytes with 100% accuracy.

No abstract