Significance We illustrate the similarity and difference in particulate matter (PM) formation between Beijing and other world regions. The periodic cycle of PM events in Beijing is regulated by meteorological conditions. While the particle chemical compositions in Beijing are similar to those commonly measured worldwide, efficient nucleation and growth over an extended period in Beijing are distinctive from the aerosol formation typically observed in other global areas. Gaseous emissions of volatile organic compounds and nitrogen oxides from urban transportation and sulfur dioxide from regional industry are responsible for large secondary PM formation, while primary emissions and regional transport of PM are insignificant. Reductions in emissions of the aerosol precursor gases from transportation and industry are essential to mediate severe haze pollution in China.

Abstract. Secondary Organic Aerosols (SOA) studied in previous laboratory experiments generally showed only slight hygroscopic growth, but a much better activity as a CCN (Cloud Condensation Nucleus) than indicated by the hygroscopic growth. This discrepancy was examined at LACIS (Leipzig Aerosol Cloud Interaction Simulator), using a portable generator that produced SOA particles from the ozonolysis of α-pinene, and adding butanol or butanol and water vapor during some of the experiments. The light scattering signal of dry SOA-particles was measured by the LACIS optical particle spectrometer and was used to derive a refractive index for SOA of 1.45. LACIS also measured the hygroscopic growth of SOA particles up to 99.6% relative humidity (RH), and a CCN counter was used to measure the particle activation. SOA-particles were CCN active with critical diameters of e.g. 100 nm and 55 nm at super-saturations of 0.4% and 1.1%, respectively. But only slight hygroscopic growth with hygroscopic growth factors ≤1.05 was observed at RH<98% RH. At RH>98%, the hygroscopic growth increased stronger than would be expected if a constant hygroscopicity parameter for the particle/droplet solution was assumed. An increase of the hygroscopicity parameter by a factor of 4-6 was observed in the RH-range from below 90% to 99.6%, and this increase continued for increasingly diluted particle solutions for activating particles. This explains an observation already made in the past: that the relation between critical super-saturation and dry diameter for activaCorrespondence to: H. Wex (wex@tropos.de) tion is steeper than what would be expected for a constant value of the hygroscopicity. Combining measurements of hygroscopic growth and activation, it was found that the surface tension that has to be assumed to interpret the measurements consistently is greater than 55 mN/m, possibly close to that of pure water, depending on the different SOA-types produced, and therefore only in part accounts for the discrepancy between hygroscopic growth and CCN activity observed for SOA particles in the past.

Abstract. Simultaneous measurements of gaseous sulfuric acid and particle number size distributions were performed to investigate aerosol nucleation and growth during CAREBeijing-2008. The analysis of the measured aerosols and sulfuric acid with an aerosol dynamic model shows the dominant role of sulfuric acid in new particle formation (NPF) process but also in the subsequent growth in Beijing. Based on the data of twelve NPF events, the average formation rates (2-13 cm −3 s −1 ) show a linear correlation with the sulfuric acid concentrations (R 2 =0.85). Coagulation seems to play a significant role in reducing the number concentration of nucleation mode particles with the ratio of the coagulation loss to formation rate being 0.41±0.16. The apparent growth rates vary from 3 to 11 nm h −1 . Condensation of sulfuric acid and its subsequent neutralization by ammonia and coagulation contribute to the apparent particle growth on average 45±18% and 34±17%, respectively. The 30% higher concentration of sulfate than organic compounds in particles during the seven sulfur-rich NPF events but 20% lower concentration of sulfate during the five sulfur-poor type suggest that organic compounds are an important contributor to the growth of the freshly nucleated particles, especially during the sulfur-poor cases.

[1] This study was part of the international field measurement Campaigns of Air Quality Research in Beijing and Surrounding Region 2006 (CAREBeijing-2006). We investigated a new particle formation event in a highly polluted air mass at a regional site south of the megacity Beijing and its impact on the abundance and properties of cloud condensation nuclei (CCN). During the 1-month observation, particle nucleation followed by significant particle growth on a regional scale was observed frequently ($30%), and we chose 23 August 2006 as a representative case study. Secondary aerosol mass was produced continuously, with sulfate, ammonium, and organics as major components. The aerosol mass growth rate was on average 19 mg m À3 h À1 during the late hours of the day. This growth rate was observed several times during the 1-month intensive measurements. The nucleation mode grew very quickly into the size range of CCN, and the CCN size distribution was dominated by the growing nucleation mode (up to 80% of the total CCN number concentration) and not as usual by the accumulation mode. At water vapor supersaturations of 0.07-0.86%, the CCN number concentrations reached maximum values of 4000-19,000 cm À3 only 6-14 h after the nucleation event. During particle formation and growth, the effective hygroscopicity parameter k increased from about 0.1-0.3 to 0.35-0.5 for particles with diameters of 40-90 nm, but it remained nearly constant at $0.45 for particles with diameters of $190 nm. This result is consistent with aerosol chemical composition data, showing a pronounced increase of sulfate. Citation: Wiedensohler, A., et al. (2009), Rapid aerosol particle growth and increase of cloud condensation nucleus activity by secondary aerosol formation and condensation: A case study for regional air pollution in northeastern China,

Particle hygroscopic growth at 90% RH (relative humidity), cloud condensation nuclei (CCN) activity, and size-resolved chemical composition were concurrently measured in the Thüringer Wald mid-level mountain range in central Germany in the fall of 2010. The median hygroscopicity parameter values, κ, of 50, 75, 100, 150, 200, and 250 nm particles derived from hygroscopicity measurements are respectively 0.14, 0.14, 0.17, 0.21, 0.24, and 0.28 during the sampling period. The closure between HTDMA (Hygroscopicity Tandem Differential Mobility Analyzers)-measured (κ_HTDMA) and chemical composition-derived (κ_chem) hygroscopicity parameters was performed based on the Zdanovskii–Stokes–Robinson (ZSR) mixing rule. Using size-averaged chemical composition, the κ values are substantially overpredicted (30 and 40% for 150 and 100 nm particles). Introducing size-resolved chemical composition substantially improved closure. We found that the evaporation of NH₄NO₃, which may happen in a HTDMA system, could lead to a discrepancy in predicted and measured particle hygroscopic growth. The hygroscopic parameter of the organic fraction, κ_org, is positively correlated with the O : C ratio (κ_org = 0.19 × (O : C) − 0.03). Such correlation is helpful to define the κ_org value in the closure study. κ derived from CCN measurement was around 30% (varied with particle diameters) higher than that determined from particle hygroscopic growth measurements (here, hydrophilic mode is considered only). This difference might be explained by the surface tension effects, solution non-ideality, gas-particle partitioning of semivolatile compounds, and the partial solubility of constituents or non-dissolved particle matter. Therefore, extrapolating from HTDMA data to properties at the point of activation should be done with great care. Finally, closure study between CCNc (cloud condensation nucleus counter)-measured (κ_CCN) and chemical composition (κ_{CCN, chem}) was performed using CCNc-derived κ values for individual components. The results show that the κ_CCN can be well predicted using particle size-resolved chemical composition and the ZSR mixing rule

The heterogeneous hydrolysis of dinitrogen pentoxide (N2O5) is important to understanding the formation of particulate nitrate (pNO3 –). Measurements of N2O5 in the surface layer taken at an urban site in Beijing are presented here. N2O5 was observed with large day-to-day variability. High N2O5 concentrations were determined during pollution episodes with the co-presence of large aerosol loads. The maximum value was 1.3 ppbv (5 s average), associated with an air mass characterized by a high level of O3. N2O5 uptake coefficients were estimated to be in the range of 0.025–0.072 using the steady-state lifetime method. As a consequence, the nocturnal pNO3 – formation potential by N2O5 heterogeneous uptake was calculated to be 24–85 μg m–3 per night and, on average, 57 μg m–3 during days with pollution. This was comparable to or even higher than that formed by the partitioning of HNO3. The results highlight that N2O5 heterogeneous hydrolysis is vital in pNO3 – formation in Beijing.

Simultaneous measurements of aerosol size, distribution of number, mass, and chemical compositions were conducted in the winter of 2007 in Beijing using a Twin Differential Mobility Particle Sizer and a Micro Orifice Uniform Deposit Impactor. Both material density and effective density of ambient particles were estimated to be 1.61 ± 0.13 g cm(-3) and 1.62 ± 0.38 g cm(-3) for PM(1.8) and 1.73 ± 0.14 g cm(-3) and 1.67 ± 0.37 g cm(-3) for PM(10). Effective density decreased in the nighttime, indicating the primary particles emission from coal burning influenced the density of ambient particles. Size-resolved material density and effective density showed that both values increased with diameter from about 1.5 g cm(-3) at the size of 0.1 μm to above 2.0 g cm(-3) in the coarse mode. Material density was significantly higher for particles between 0.56 and 1.8 μm during clean episodes. Dynamic Shape Factors varied within the range of 0.95-1.13 and decreased with particle size, indicating that coagulation and atmospheric aging processes may change the shape of particles.

Abstract. Atmospheric new particle formation (NPF) is an important phenomenon in terms of global particle number concentrations. Here we investigated the frequency of NPF, formation rates of 10 nm particles, and growth rates in the size range of 10–25 nm using at least 1 year of aerosol number size-distribution observations at 36 different locations around the world. The majority of these measurement sites are in the Northern Hemisphere. We found that the NPF frequency has a strong seasonal variability. At the measurement sites analyzed in this study, NPF occurs most frequently in March–May (on about 30 % of the days) and least frequently in December–February (about 10 % of the days). The median formation rate of 10 nm particles varies by about 3 orders of magnitude (0.01–10 cm−3 s−1) and the growth rate by about an order of magnitude (1–10 nm h−1). The smallest values of both formation and growth rates were observed at polar sites and the largest ones in urban environments or anthropogenically influenced rural sites. The correlation between the NPF event frequency and the particle formation and growth rate was at best moderate among the different measurement sites, as well as among the sites belonging to a certain environmental regime. For a better understanding of atmospheric NPF and its regional importance, we would need more observational data from different urban areas in practically all parts of the world, from additional remote and rural locations in North America, Asia, and most of the Southern Hemisphere (especially Australia), from polar areas, and from at least a few locations over the oceans.