Two dimensional (2D) hybrid perovskites have attracted a great deal of interest because of their appropriate photovoltaic efficiency and environmental stability. Although some 2D hybrid perovskites with sulfur-containing amines have been reported, the cation having the mercaptan group has not been well explored yet. In this work, cysteamine (Cya, HS­(CH2)2NH2), a mercaptan-containing amine, was introduced into 2D hybrid perovskite. Two 2D lead iodides with different structures, (HCya)2PbI4 (1) and (HCya)7Pb4I15 (2), were isolated as a red low-temperature phase and a yellow high-temperature phase, respectively. X-ray single-crystal structural analysis showed that the red phase 1 is a single layered corner-shared perovskite and that the yellow phase 2 is a corner/edge-shared quasi-2D perovskite. A thermo-induced reversible 1 to 2 phase transition was found in this synthetic system. The configuration of HCya cation greatly influences the crystallization equilibrium, generating different structures of the lead halides. The single-crystal structure of 1 is discussed in comparison with that of (HAE)2PbI4 (AE = HO­(CH2)2NH2), an analogue of 1. The different effects of OH and SH groups on the 2D frameworks are studied based on their hydrogen bonding properties. More remarkably, although the two perovskites have similar structures, the (HCya)2PbI4 (1) has an intrinsic water stability that is much more stable than (HAE)2PbI4, which should be attributed to the affinity of the SH group with lead on the surface of the lead halide.

Although pristine metal–organic framework (MOF) anodes for lithium-ion batteries (LIBs) show moderate activities and relatively stable cycling, the poor rate capability of the MOF anodes limited their applications in the development of a new generation of energy storage. Herein, the electric active CoII ion is selected to coordinate with redox-active S-rich tetrathiafulvalene (TTF) derivatives to create two TTF-Co-MOFs, formulated as [Co2(py-TTF-py)2(BDC)2]·2DMF·H2O (TTF-Co-MOF 1) and [Co2(py-TTF-py)2(BPDC)2]·3DMF·3H2O (TTF-Co-MOF 2), where py-TTF-py = 2,6-bis­(4′-pyridyl)­tetrathiafulvalene, H2BDC = terephthalic acid, H2BPDC = biphenyl-4,4′-dicarboxylic acid, and DMF = N,N-dimethylformamide. Crystallographic characterization indicated that the two MOFs possess similar 2-fold-interpenetrating 3D frameworks but with two different pore sizes. The pore-size-dependent performances of the TTF-Co-MOFs were explored to optimize the MOFs as the anode materials for LIBs. TTF-Co-MOF 1 presents a high reversible specific capacity of 1186.6 mAh g–1 at 200 mA g–1 after 287 cycles. The rate capability is greatly enhanced by the introduction of CoII into TTF-based MOFs with specific capacities of 1028.6 mAh g–1 at 5 A g–1 and 966.5 mAh g–1 at 10 A g–1. On the basis of the series analysis of theoretical calculations, electrochemical impedance spectroscopy, and crystal structures, it is found that the CoII metal centers play a bridging role in charge transport within the MOF framework, which is beneficial for the transportation of Li ions. The competitive performances of TTF-Co-MOF 1 are attributed to the synergistic effect of the CoII metal centers and S-rich TTF ligand as well as suitable porosity. The study shed some light for the fabrication of advanced energy storage devices through the rational design of MOF-based anode materials.

No abstract

Introducing electronically active organic components into lower dimensional metal-halide compounds is an effective strategy to improve electronic properties of hybrid metal halide materials. We have previously used this strategy to...

Metal–organic frameworks (MOFs) have attracted noticeable attention as promising candidates for electrochemical energy storage. However, the lack of electrical conductivity and the weak stability of most MOFs result in poor electrochemical performances. Here, a tetrathiafulvalene (TTF)-based complex, formulated as [(CuCN)2(TTF(py)4)] (1) (TTF-(py)4 = tetra(4-pyridyl)-TTF), is assembled by in situ generation of coordinated CN– from a nontoxic source. Single-crystal X-ray diffraction analysis reveals that compound 1 possesses a two-dimensional layered planar structure, which is further stacked in parallel to form a three-dimensional supramolecular framework. The planar coordination environment of 1 is the first example of a TTF-based MOF. Attributed to the unique structure and redox TTF ligand, the electrical conductivity of 1 is significantly increased by 5 orders of magnitude upon iodine treatment. The iodine-treated 1 (1-ox) electrode displays typical battery-type behavior through electrochemical characterizations. The supercapattery based on the 1-ox positrode and AC negatrode presents a high specific capacity of 266.5 C g–1 at a specific current of 1 A g–1 with a remarkable specific energy of 62.9 Wh kg–1 at a specific power of 1.1 kW kg–1. The excellent electrochemical performance of 1-ox is one of the best among those reported supercapatteries, demonstrating a new strategy for developing MOF-based electrode materials.