No abstract

No abstract

BACKGROUND Incorporation of nanofillers into the polyamide (PA) layer of thin‐film composite (TFC) membrane could improve membrane surface properties for enhanced water separation efficiency. However, most nanofillers do not disperse well in organic medium. In this work, the surface of titanate nanotubes (TNTs) was modified via the plasma‐enhanced chemical vapour deposition (PECVD) method in order to promote its dispersion rate (in organic medium) during thin‐film nanocomposite (TFN) membrane fabrication. RESULTS Fourier transform infrared (FTIR) analysis confirmed the surface chemistry of TNTs coated by hexafluorobutyl acrylate (HFBA) or hydroxyethyl methacrylate (HEMA) via PECVD method. The effects of embedding modified TNTs into the PA layer on membrane surface morphology, hydrophilicity and performance were also investigated and the results were further compared with commercial reverse osmosis (RO) membranes. It was found that the incorporation of HFBA‐ and HEMA‐modified TNTs could enhance the membrane water permeability by >25% and >40%, respectively, without compromising their salt rejection. The boron rejections of TFN membranes incorporated with HFBA‐ and HEMA‐modified TNTs meanwhile were recorded at 75.56% and 70.73%, respectively; these values were relatively higher than those for the self‐synthesized TFC (68.57%) and commercial RO membranes (37–39%). The developed TFN membranes also exhibited higher fouling tolerance than the commercial RO membranes, achieving >94% of water flux regeneration as a result of enhanced membrane surface hydrophilicity. CONCLUSION Compared to hydrophilic modification using HEMA, nanofillers modified by hydrophobic HFBA proved more effective at producing a PA layer with better nanofiller distribution, making the resultant TFN membrane more suitable for desalination processes. © 2019 Society of Chemical Industry

No abstract

The non-selective property of conventional polyurethane (PU) foam tends to lower its oil absorption efficiency. To address this issue, we modified the surface properties of PU foam using a rapid solvent-free surface functionalization approach based on the chemical vapor deposition (CVD) method to establish an extremely thin yet uniform coating layer to improve foam performance. The PU foam was respectively functionalized using different monomers, i.e., perfluorodecyl acrylate (PFDA), 2,2,3,4,4,4-hexafluorobutyl acrylate (HFBA), and hexamethyldisiloxane (HMDSO), and the effect of deposition times (1, 5 and 10 min) on the properties of foam was investigated. The results showed that all the modified foams demonstrated a much higher water contact angle (i.e., greater hydrophobicity) and greater absorption capacities compared to the control PU foam. This is due to the presence of specific functional groups, e.g., fluorine (F) and silane (Si) in the modified PU foams. Of all, the PU/PHFBAi foam exhibited the highest absorption capacities, recording 66.68, 58.15, 53.70, and 58.38 g/g for chloroform, acetone, cyclohexane, and edible oil, respectively. These values were 39.19–119.31% higher than that of control foam. The promising performance of the PU/PHFBAi foam is due to the improved surface hydrophobicity attributed to the original perfluoroalkyl moieties of the HFBA monomer. The PU/PHFBAi foam also demonstrated a much more stable absorption performance compared to the control foam when both samples were reused for up to 10 cycles. This clearly indicates the positive impact of the proposed functionalization method in improving PU properties for oil absorption processes.

No abstract

No abstract

No abstract