Defined aggregates of polymers such as polymeric micelles are of great importance in the development of pharmaceutical formulations. The amount of drug that can be formulated by a drug delivery system is an important issue, and most drug delivery systems suffer from their relatively low drug-loading capacity. However, as the loading capacities increase, i.e., promoted by good drug–polymer interactions, the drug may affect the morphology and stability of the micellar system. We investigated this effect in a prominent system with very high capacity for hydrophobic drugs and found extraordinary stability as well as a profound morphology change upon incorporation of paclitaxel into micelles of amphiphilic ABA poly(2-oxazoline) triblock copolymers. The hydrophilic blocks A comprised poly(2-methyl-2-oxazoline), while the middle blocks B were either just barely hydrophobic poly(2-n-butyl-2-oxazoline) or highly hydrophobic poly(2-n-nonyl-2-oxazoline). The aggregation behavior of both polymers and their formulations with varying paclitaxel contents were investigated by means of dynamic light scattering, atomic force microscopy, (cryogenic) transmission electron microscopy, and small-angle neutron scattering. While without drug, wormlike micelles were present, after incorporation of small amounts of drugs only spherical morphologies remained. Furthermore, the much more hydrophobic poly(2-n-nonyl-2-oxazoline)-containing triblock copolymer exhibited only half the capacity for paclitaxel than the poly(2-n-butyl-2-oxazoline)-containing copolymer along with a lower stability. In the latter, contents of paclitaxel of 8 wt % or higher resulted in a raspberry-like micellar core.

We have investigated the structural changes in thin films of lamellar poly(styrene-b-butadiene) diblock copolymers during treatment with saturated cyclohexane vapor, a solvent slightly selective for polybutadiene. Using real-time, in-situ grazing-incidence small-angle X-ray scattering (GISAXS), the swelling and the rearrangement of the lamellae were investigated with a time resolution of a few seconds, and the underlying processes on the molecular level were identified. After a few minutes in vapor, a transient state with a more well-defined and more long-range ordered lamellar orientation was encountered. Additional parallel lamellae formed which we attribute to the increased degree of coiling of the polymers in the swollen state. Eventually, the film became disordered. These changes are attributed to the increased mobility of the swollen polymers and the gradually decreasing segment-segment interaction parameter in the film as solvent is absorbed.

We have studied the structural rearrangements in a lamellae-forming poly(styrene-b-butadiene) film during exposure to toluene vapor. Real-time, in situ grazing-incidence small-angle X-ray scattering allowed us to identify distinct kinetic regimes: First, the lamellae swell linearly, and the blocks stretch uniaxially. Then, the blocks relax to a more globular molecular conformation, and the lamellar thickness abruptly shrinks again. The increased interfacial area culminates in a dramatic instability causing a major rearrangement of the lamellar stack and the formation of new lamellae. Finally, the lamellar thickness levels off, and the interfaces flatten again.