Pressure fluctuations play an essential role in the transport of turbulent kinetic energy and vibrational loading. This study focuses on examining the effect of wall cooling on pressure fluctuations in compressible turbulent boundary layers by high-fidelity direct numerical simulations. Pressure fluctuations result from the vorticity mode and the acoustic mode that are both closely dependent on compressibility. To demonstrate the effects of wall cooling at various compressibility intensities, three free-stream Mach numbers are investigated, i.e. $M_\infty =0.5$ , 2.0 and 8.0, with real gas effects being absent for $M_\infty =8.0$ due to a low enthalpy inflow. Overall, opposite effects of wall cooling on pressure fluctuations are found between the subsonic/supersonic cases and the hypersonic case. Specifically, the pressure fluctuations normalized by wall shear stress $p^\prime _{rms}/\tau _w$ are suppressed in the subsonic and supersonic cases, while enhanced in the hypersonic case near the wall. Importantly, travelling-wave-like alternating positive and negative structures (APNS), which greatly contribute to pressure fluctuations, are identified within the viscous sublayer and buffer layer in the hypersonic cases. Furthermore, generating mechanisms of pressure fluctuations are explored by extending the decomposition based on the fluctuating pressure equation to compressible turbulent boundary layers. Pressure fluctuations are decomposed into five components, in which rapid pressure, slow pressure and compressible pressure are dominant. The suppression of pressure fluctuations in the subsonic and supersonic cases is due to both rapid pressure and slow pressure being suppressed by wall cooling. In contrast, wall cooling strengthens compressible pressure for all Mach numbers, especially in the hypersonic case, resulting in increased wall pressure fluctuations. Compressible pressure plays a leading role in the hypersonic case, mainly due to the APNS. Essentially, the main effects of wall cooling can be interpreted by the suppression of the vorticity mode and the enhancement of the acoustic mode.

No abstract

The influence of tilt on flow reversals in two-dimensional thermal convection in rectangular cells with two typical aspect ratios, $\unicode[STIX]{x1D6E4}=\text{width/height}=1$ and 2, are investigated by means of direct numerical simulations. For $\unicode[STIX]{x1D6E4}=1$, tilt tends to suppress flow reversals. However, it is found that flow reversals characterized by two main rolls are promoted by tilt for $\unicode[STIX]{x1D6E4}=2$, which are even observed for some cases of small Prandtl numbers ($Pr$) and large tilt angles ($\unicode[STIX]{x1D6FD}$). Different from level cases where the four corner rolls all have opportunities to grow and trigger a flow reversal, the reversals in an anticlockwise tilted cell with $\unicode[STIX]{x1D6E4}=2$ are always led by the growth of the bottom-right or the top-left corner roll. Tilt is favourable for the growth of the bottom-right or the top-left corner roll and thus for breaking the balance between the two main rolls and triggering a flow reversal. The mode decomposition analysis shows that the appearance of the intermediate single-roll mode is crucial for reversals, and flow reversals in a tilted cell with $\unicode[STIX]{x1D6E4}=2$ can be viewed as a mode competition process between single-roll mode and horizontally adjacent double-roll mode. They can only occur in a limited range of $\unicode[STIX]{x1D6FD}$ where the two modes have comparable strength. Furthermore, the Nusselt numbers at the hot plate $Nu_{h}$ and at the cold plate $Nu_{c}$ behave differently during a flow reversal for $\unicode[STIX]{x1D6E4}=2$ due to the preference of single corner roll growth.

Penetrative turbulent Rayleigh-Bénard convection which depends on the density maximum of water near 4 • C is studied using two-dimensional (2D) and three-dimensional (3D) direct numerical simulations (DNS). The working fluid is water near 4 • C with Prandtl number P r = 11.57. The considered Rayleigh numbers Ra range from 10 7 to 10 10 . The density inversion parameter θ m varies from 0 to 0.9. It is found that the ratio of the top and bottom thermal boundary-layer thickness (F λ = λ θ t /λ θ b ) increases with increasing θ m , and the relationship between F λ and θ m seems to be independent of Ra. The centre temperature θ c is enhanced compared to that of Oberbeck-Boussinesq (OB) cases, as θ c is related to F λ with 1/θ c = 1/F λ + 1, θ c is also found to have a universal relationship with θ m which is independent of Ra. Both the Nusselt number N u and the Reynolds number Re decrease with increasing θ m , the normalized Nusselt number N u(θ m )/N u(0) and Reynolds number Re(θ m )/Re(0) also have universal relationships with θ m which seem to be independent of both Ra and the aspect ratio Γ . The scaling exponents of N u ∼ Ra α and Re ∼ Ra β are found to be insensitive to θ m despite of the remarkable change of the flow organizations.

No abstract