Upper limb disability is one of the major adversities faced by post-stroke patients. Eating is one of the fundamental activities of survival for all living beings. The robotic rehabilitation systems for people with upper limb disabilities must have the capability of assisting the patients, providing appropriate forces/torques, during various eating activities. In this study, a 3-D, four-DOF dynamic , mathematical model of human arm , including wrist and elbow joints, focusing on elbow flexion/extension motion, forearm pronation/supination, wrist flexion/extension and wrist adduction/abduction is formulated, for predicting the torques during different eating activities. A simulation study and experimental validation has been conducted involving five different food types and using two types of cutlery, which are, a fork and a spoon, to study their effect on the corresponding torques produced. It was observed that the maximum torque is obtained in both wrist and elbow joint when the subject digs into the food and eats (event B) in the majority of the eating tasks. The accuracy of the model, in terms of torque prediction, was compared to that of the load cell, for all eating activities, using RMSE as a statistical measure, to the test the performance of the model. The results indicate that 3-D dynamic model formulated fits all the torques for all eating activities very well, with the average RMSE of 0.05 Nm and the performance of the model is good. These results verify that the proposed Kane 's model, successfully models the HUL, during different eating tasks and using different types of cutlery.
The focus of this research is to analyse both human hand motion and force, during eating, with respect to differing food characteristics and cutlery (including a fork and a spoon). A glove consisting of bend and force sensors has been used to capture the motion and contact force exerted by fingers during different eating activities. The Pearson correlation coefficient has been used to show that a significant linear relationship exists between the bending motion of the fingers and the forces exerted during eating. Analysis of variance (ANOVA) and independent samples t-tests are performed to establish whether the motion and force exerted by the fingers while eating is influenced by the different food characteristics and cutlery. The middle finger motion showed the least positive correlation with index fingertip and thumb-tip force, irrespective of the food characteristics and cutlery used. The ANOVA and t-test results revealed that bending motion of the index finger and thumb varies with respect to differing food characteristics and the type of cutlery used (fork/spoon), whereas the bending motion of the middle finger remains unaffected. Additionally, the contact forces exerted by the thumb tip and index fingertip remain unaffected with respect to differing food types and cutlery used.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.