The growing concern about the environmental consequences of anthropogenic CO2 emissions significantly stimulated the research of low-cost, efficient, and recyclable solid adsorbents for CO2 capture. In this work, a series of MgO-supported mesoporous carbon nitride adsorbents with different MgO contents (xMgO/MCN) was prepared using a facile process. The obtained materials were tested for CO2 capture from 10 vol% CO2 mixture gas with N2 using a fixed bed adsorber at atmospheric pressure. At 25 ºC, the bare MCN support and unsupported MgO samples demonstrated CO2 capture capacities of 0.99, and 0.74 mmol g−1, respectively, which were lower than those of the xMgO/MCN composites.The incorporation of MgO into the MCN improved the CO2 uptake, and the 20MgO/MCN exhibited the highest CO2 capture capacity of 1.15 mmol g−1 at 25 °C. The improved performance of the 20MgO/MCN nanohybrid can be possibly assigned to the presence of high content of highly dispersed MgO NPs along with its improved textural properties in terms of high specific surface area (215 m2g−1), large pore volume (0.22 cm3g−1), and abundant mesoporous structure. The efffects of temperature and CO2 flow rate were also investigated on the CO2 capture performance of 20MgO/MCN. Temperature was found to have a negative influence on the CO2 capture capacity of the 20MgO/MCN, which decreased from 1.15 to 0.65 mmol g−1with temperature rise from 25 C to 150º C, due to the endothermicity of the process. Similarly, the capture capacity decreased from 1.15 to 0.54 mmol g−1 with the increase of the flow rate from 50 to 200 ml minute−1 respectively. Importantly, 20MgO/MCN showed excellent reusability with consistent CO2 capture capacity over five sequential sorption–desorption cycles, suggesting its suitability for the practical capture of CO2.
The CO2 methanation technique not only gives a solution for mitigating CO2 emissions but can also be used to store and convey low-grade energy. The basic character and large surface area of mesoporous carbon nitride, (MCN), are considered promising properties for the methanation of CO2. So, a series (5–20 wt.%) of Ni-doped mesoporous carbon nitride catalysts were synthesized by using the impregnation method for CO2 methanation. the prepared catalysts were characterized by several physicochemical techniques including XRD, BET, FT-IR, Raman spectroscopy, TEM, TGA analysis, Atomic Absorption, H2-TPR, and CO2-TPD. The catalytic performance was investigated at ambient pressure and temperature range (200–500 °C) using online Gas chromatography system. The prepared catalysts showed good performance where 15%Ni/MCN exhibited the best catalytic conversion and methane yield with 100% methane selectivity at 450 °C for investigated reaction conditions.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.