Габелая Д.И., к.т.н., доцент кафедры металлургии, машиностроения и технологического оборудования ( digabelaia@chsu.ru ) Кабаков З.К., д.т.н., профессор кафедры металлургии, машиностроения и технологического оборудования ( zkkabakov@chsu.ru ) Мащенко М.А., к.т.н., доцент кафедры металлургии, машиностроения и технологического оборудования Череповецкий государственный университет (162600, Россия, Вологодская обл., Череповец, пр. Луначарского, 5) Аннотация. Представлена новая методика расчета температурных зависимостей удельных объемов сплавов равновесной системы Fe - C, основанная на известных расчетных и эмпирических зависимостях для определения изменения удельных объемов фаз от температуры и содержания углерода. Ранее большинство подобного рода расчетов основывалось на зависимостях С.Ф. Юрьева, которые получены для температуры ниже 1200 °С. При использовании этих формул при температурах выше 1200 °С удельный объем аустенита превышает удельный объем феррита. Однако известно, что аустенит имеет наименьший удельный объем среди всех фаз системы Fe - C. В связи с этим возникает необходимость в использовании других зависимостей, которые бы не противоречили физике процессов полиморфных и фазовых превращений в системе Fe - C. Получены общие зависимости для расчета удельных объемов сплавов отдельно для трех интервалов концентраций углерода, в которых изменения долей фаз от температуры рассчитываются по равновесной диаграмме Fe - C с использованием правила рычага. В качестве примера представлены результаты расчетного определения удельных объемов сплавов с содержанием углерода 0,05, 0,13 и 0,33 % в интервале температур 20 - 1600 °С. Выполнено сравнение представленных результатов с полученными с помощью пакета расчета фазовых диаграмм JMatPro®, на основе которого установлена адекватность предложенной расчетной методики. Разработанная методика может быть использована для расчетного определения удельных объемов сплавов, а также их плотности и коэффициента линейного расширения в зависимости от температуры и концентрации углерода. Полученные формулы для расчета удельных объемов позволяют корректно моделировать процессы затвердевания, охлаждения и усадки заготовок при непрерывной разливке сталей углеродистых марок с учетом эффектов фазовых превращений, а также использовать полученные результаты при настройке оборудования МНЛЗ. Ключевые слова: удельный объем, плотность, фаза, усадка, линейное расширение.