A technique of layer-by-layer (LbL) self-assembly was used to prepare transparent multilayered gas barrier films consisting of graphene oxide (GO)/branched poly(ethylenimine) (BPEI) on a poly(ethylene terephthalate) substrate. The effect of the GO suspension pH on the nanostructure and oxygen barrier properties of the GO/BPEI film was investigated. The oxygen barrier properties of the assemblies were shown to be highly dependent on the pH. It was demonstrated that the film assemblies prepared using a GO suspension with a pH of 3.5 exhibited very dense and ordered structures and delivered very low oxygen transmission rates (the lowest was <0.05 cm(3) m(-2) day(-1)). The assemblies were characterized with ultraviolet-visible spectroscopy and ellipsometry to identify the film growth mechanism, and the result indicated a linear growth behavior. To analyze the nanostructure of the films, atomic force microscopy, transmission electronic microscopy, and grazing incidence wide-angle X-ray diffraction were used.

A thin SiO(x) selective surface layer was formed on a series of cross-linked poly(dimethylsiloxane) (PDMS) membranes by exposure to ultraviolet light at room temperature in the presence of ozone. The conversion of the cross-linked polysiloxane to SiO(x) was monitored by attenuated total reflectance Fourier transform infrared (ATR-FTIR) spectroscopy, X-ray photoelectron spectroscopy (XPS), energy-dispersive X-ray (EDX) microanalysis, contact angle analysis, and atomic force microscopy (AFM). The conversion of the cross-linked polysiloxane to SiO(x) increased with UV-ozone exposure time and cross-linking agent content, and the surface possesses highest conversion. The formation of a SiO(x) layer increased surface roughness, but it decreased water contact angle. Gas permeation measurements on the UV-ozone exposure PDMS membranes documented interesting gas separation properties: the O(2) permeability of the cross-linked PDMS membrane before UV-ozone exposure was 777 barrer, and the O(2)/N(2) selectivity was 1.9; after UV-ozone exposure, the permeability decreased to 127 barrer while the selectivity increased to 5.4. The free volume depth profile of the SiO(x) layer was investigated by novel slow positron beam. The results show that free volume size increased with the depth, yet the degree of siloxane conversion to SiO(x) does not affect the amount of free volume.

No abstract

No abstract

No abstract

No abstract

No abstract

This work introduces the preparation of zeolite-filled porous mixed matrix membranes (MMMs) and discusses their potential use for air separation. Porous polysulfone (PSF) matrix membranes were prepared using the nonsolvent-induced phase separation process. Scanning electron microscope and gas permeation experiments suggested the presence of closed pores in the porous matrix membranes. Furthermore, porous MMMs containing zeolite 4A particles as filler were prepared and characterized. The permeation properties of porous MMMs were highly dependent on the zeolite content. The introduction of zeolite particles distorted the closed pores in the PSF matrix and formed nonselective voids which resulted in very high oxygen flux but low O 2 /N 2 selectivity. The annealing technique for modifying the nonselective pores present in the polymer−zeolite interface is also described in this study. The resulting annealed porous MMMs had the ability to separate O 2 from N 2 more effectively than traditional dense MMMs.