Although drug-eluting embolic agents universally loaded doxorubicin within 1 hour, the elution amounts, rates of release, diameter shrinkage, and times in suspension varied by product.

In this paper the determination of taxol and the related compounds 10-deacetyltaxol, cephalomannine and 10-deacetylcephalomannine in various parts of Tarus cuspidatu Sieb et Zucc. is reported. All four compounds were well separated on a 5 pm Spheri-5 RP-18 column with a mobile phase composed of water:acetonitrile:tetrahydrofuran (55:35:10). The concentrations of these compounds are quite different for different parts of the plant and are highest in stem bark. Furthermore, the content is related to the age of the plant, the older plants containing larger quantities of taxane diterpenoids. We have also found that the contents of taxol and related compounds in the shrub are usually higher than those in the tree.

Fire retardancy of melamine-modified ureaformaldehyde resin (MUF) containing intumescent fire-retardant ammonium polyphosphate (APP) (MUF/APP) was conducted by cone calorimeter with surface treatment of medium density fiberboard (MDF). The results showed that the six MUF resins synthesized with different F/(M ? U) and M/U molar ratios containing APP significantly improved the fire retardancy of the MDF by prolonging ignition time, reducing heat release rate and total heat release, and decreasing mass loss rate. The fire-retardant properties of the six synthesized MUF/APP acted differently even though each MUF resin containing the same mass ratio of APP. The melamine content in the MUF should not be too high, otherwise it would decrease the fire-retardant properties of MUF/APP. Based on this study, the higher the APP amounts, the better the fire-retardant performance of the resin was. The fire retardancy of MUF/APP increased with the increase in the amount of glue that spread on the material surface. However, only the amount of glue spread exceeded 250 g/m 2 , whereas the ability of MUF/APP in inhibiting heat release did not increase significantly any longer.

A novel type of flame-retardant decorated plywood (FDP) was designed and prepared based on one kind of intumescent flame-retardant adhesive. The flame-retardant adhesive was composed of the phosphorous-nitrogen flame retardant and melamine urea formaldehyde (MUF) resin. An adhesive was placed between the plywood substrate and the decorative veneer. The shear strength of the FDP satisfied the Class II (GB/T 9846) when the ratio of flame-retardant and MUF was less than 0.65. The thermal stability of the flame-retardant adhesive was measured by thermogravimetric analysis (TGA). The intumescent behaviors of adhesives were systematically investigated. The morphological and chemical structures of the intumescent char of the flame-retardant adhesive were characterized by the scanning electron microscopy (SEM) and Fourier transform infrared spectra (FTIR), respectively. The fire performance of FDP was assessed by the cone calorimeter and the single burning item test. The FDP exhibited the most effective barrier when the optimized ratio of ammonium polyphosphate (APP) and pentaerythritol (PER) in the adhesive is 3. The flame-retardant class of FDP could be up to class B1(B) according to GB/T 8624.