Introducing bio-oil into phenolic foam (PF) can effectively improve the toughness of PF, but its flame retardant performance will be adversely affected and show a decrease. To offset the decrease in flame retardant performance, montmorillonite (MMT) can be added as a promising alternative to enhance the flame resistance of foams. The present work reported the effects of MMT on the chemical structure, morphological property, mechanical performance, flame resistance, and thermal stability of bio-oil phenolic foam (BPF). The Fourier transform infrared spectroscopy (FT-IR) result showed that the –OH group peaks shifted to a lower frequency after adding MMT, indicating strong hydrogen bonding between MMT and bio-oil phenolic resin (BPR) molecular chains. Additionally, when a small content of MMT (2–4 wt %) was added in the foamed composites, the microcellular structures of bio-oil phenolic foam modified by MMT (MBPFs) were more uniform and compact than that of BPF. As a result, the best performance of MBPF was obtained with the addition of 4 wt % MMT, where compressive strength and limited oxygen index (LOI) increased by 31.0% and 33.2%, respectively, and the pulverization ratio decreased by 40.6% in comparison to BPF. These tests proved that MMT can blend well with bio-oil to effectively improve the flame resistance of PF while enhancing toughness.

The aging properties of phenol-formaldehyde resin modified by bio-oil (BPF) were analyzed using ultraviolet (UV) weathering. The variations on bonding strength of BPF were measured, and the changes on microstructure, atomic composition and chemical structure of BPF were characterized by using a scanning electron microscope (SEM), X-ray photoelectron spectroscopy (XPS) and nuclear magnetic resonance (NMR), respectively. With the increase of aging time, the bonding strength decreased gradually, the resin surface became rougher and the O/C radio of resin surface increased. However, the loss rate of bonding strength of BPFs was 9.6–23.0% lower than that of phenol-formaldehyde resin (PF) after aging 960 h. The aging degree of BPF surfaces was smaller in comparison to PF at the same aging time. These results showed that the bio-oil had a positive effect on the anti-aging property. Analytical results revealed that with increasing the aging time, the XPS peak area of C–C/C–H decreased, while that of C=O and O–C=O increased. The intensity of methylene and ether bridges in NMR analysis decreased along with increasing the intensity of aldehydes, ketones, acids and esters. These results indicated that the aging mechanism of BPF was a process of the breakage of molecular chains and formation of oxygen-containing compounds.

No abstract

No abstract

No abstract