In this work, we report an available technique for the effective reduction of graphene oxide (GO) and the fabrication of nanostructured zirconia reduced graphene oxide powder via a hydrothermal method. Characterization of the obtained nano-hybrid structure materials was carried out using a scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-ray diffraction (XRD), Raman spectroscopy, X-ray photoelectron spectroscopy (XPS) and Fourier-transform infrared spectroscopy (FTIR). The confirmation that GO was reduced and the uniform distribution of zirconia nanoparticles on graphene oxide sheets during synthesis was obtained due to these techniques. This has presented new opportunities and prospects to use this uncomplicated and inexpensive technique for the development of zirconia/graphene nanocomposite powders.

Spark plasma sintering (SPS) is an extremely fast solidification technique for compounds that are difficult to sinter within the material group metals, ceramics or composites. SPS uses a uniaxial pressure and a very rapid heating cycle to consolidate these materials. This direct way of heating allows the application of very high heating and cooling rates, enhancing densification over grain growth promoting diffusion mechanisms allowing maintaining the intrinsic properties of nanopowders in their fully dense products. The ZrO2-TiN cermets prepared by SPS processing achieves the enhanced mechanical properties with the hardness of 15.1 GPa and the fracture toughness of 9.1 MPa∙m1/2 in comparison to standard reference ZrO2-TiN material.

An effective approach for preparing electrically conductive multiscale SiAlON-based nanocomposites with 10 wt.% and 20 wt.% of titanium nitride was developed. Fully dense samples were obtained by spark plasma sintering (SPS) at 1700 °C and 80 MPa for 30 min. The morphology of nanocomposites was observed using scanning electron microscopy and the effects of TiN particles on the mechanical properties and electrical resistivity were studied. It was found that the addition of 20 wt.% TiN increased the hardness and fracture toughness compared to the commercial ceramic analogue TC3030. Meanwhile, the presence of TiN particles reduced the flexural strength of the nanocomposites due to the shrinkage difference between TiN particles and ceramic matrix during cooling, which led to tensile residual stresses and, consequently, to changes in strength values. In addition, the electrical resistivity of nanocomposites decreased with the increase of TiN content and reached 1.6 × 10−4 Ω∙m for 20 wt.% amount of second phase, which consequently made them suitable for electrical discharge machining. In addition to enhanced mechanical and electrical properties, under identical conditions, SPS-sintered multiscale nanocomposites exhibited a higher wear resistance (more than about 1.5-times) compared to the commercial sample due to their higher toughness and hardness.