Underwater Wireless Sensor Networks (UWSNs) contain several components such as vehicles and sensors that are deployed in a specific acoustic area to perform collaborative monitoring and data collection tasks. These networks are used interactively between different nodes and ground-based stations. Presently, UWSNs face issues and challenges regarding limited bandwidth, high propagation delay, 3D topology, media access control, routing, resource utilization, and power constraints. In the last few decades, research community provided different methodologies to overcome these issues and challenges; however, some of them are still open for research due to variable characteristics of underwater environment. In this paper, a survey of UWSN regarding underwater communication channel, environmental factors, localization, media access control, routing protocols, and effect of packet size on communication is conducted. We compared presently available methodologies and discussed their pros and cons to highlight new directions of research for further improvement in underwater sensor networks.

Some smartphones have the capability to process video streams from both the front- and rear-facing cameras simultaneously. This paper proposes a new monitoring method for simultaneous estimation of heart and breathing rates using dual cameras of a smartphone. The proposed approach estimates heart rates using a rear-facing camera, while at the same time breathing rates are estimated using a non-contact front-facing camera. For heart rate estimation, a simple application protocol is used to analyze the varying color signals of a fingertip placed in contact with the rear camera. The breathing rate is estimated from non-contact video recordings from both chest and abdominal motions. Reference breathing rates were measured by a respiration belt placed around the chest and abdomen of a subject; reference heart rates (HR) were determined using the standard electrocardiogram. An automated selection of either the chest or abdominal video signal was determined by choosing the signal with a greater autocorrelation value. The breathing rate was then determined by selecting the dominant peak in the power spectrum. To evaluate the performance of the proposed methods, data were collected from 11 healthy subjects. The breathing ranges spanned both low and high frequencies (6–60 breaths/min), and the results show that the average median errors from the reflectance imaging on the chest and the abdominal walls based on choosing the maximum spectral peak were 1.43% and 1.62%, respectively. Similarly, HR estimates were also found to be accurate.

This paper proposes accurate respiratory rate estimation using nasal breath sound recordings from a smartphone. Specifically, the proposed method detects nasal airflow using a built-in smartphone microphone or a headset microphone placed underneath the nose. In addition, we also examined if tracheal breath sounds recorded by the built-in microphone of a smartphone placed on the paralaryngeal space can also be used to estimate different respiratory rates ranging from as low as 6 breaths/min to as high as 90 breaths/min. The true breathing rates were measured using inductance plethysmography bands placed around the chest and the abdomen of the subject. Inspiration and expiration were detected by averaging the power of nasal breath sounds. We investigated the suitability of using the smartphone-acquired breath sounds for respiratory rate estimation using two different spectral analyses of the sound envelope signals: The Welch periodogram and the autoregressive spectrum. To evaluate the performance of the proposed methods, data were collected from ten healthy subjects. For the breathing range studied (6-90 breaths/min), experimental results showed that our approach achieves an excellent performance accuracy for the nasal sound as the median errors were less than 1% for all breathing ranges. The tracheal sound, however, resulted in poor estimates of the respiratory rates using either spectral method. For both nasal and tracheal sounds, significant estimation outliers resulted for high breathing rates when subjects had nasal congestion, which often resulted in the doubling of the respiratory rates. Finally, we show that respiratory rates from the nasal sound can be accurately estimated even if a smartphone's microphone is as far as 30 cm away from the nose.

According to the survey on various health centres, smart log-based multi access physical monitoring system determines the health conditions of humans and their associated problems present in their lifestyle. At present, deficiency in significant nutrients leads to deterioration of organs, which creates various health problems, particularly for infants, children, and adults. Due to the importance of a multi access physical monitoring system, children and adolescents’ physical activities should be continuously monitored for eliminating difficulties in their life using a smart environment system. Nowadays, in real-time necessity on multi access physical monitoring systems, information requirements and the effective diagnosis of health condition is the challenging task in practice. In this research, wearable smart-log patch with Internet of Things (IoT) sensors has been designed and developed with multimedia technology. Further, the data computation in that smart-log patch has been analysed using edge computing on Bayesian deep learning network (EC-BDLN), which helps to infer and identify various physical data collected from the humans in an accurate manner to monitor their physical activities. Then, the efficiency of this wearable IoT system with multimedia technology is evaluated using experimental results and discussed in terms of accuracy, efficiency, mean residual error, delay, and less energy consumption. This state-of-the-art smart-log patch is considered as one of evolutionary research in health checking of multi access physical monitoring systems with multimedia technology.

Sleep disorders are a common affliction for many people even though sleep is one of the most important factors in maintaining good physiological and emotional health. Numerous researchers have proposed various approaches to monitor sleep, such as polysomnography and actigraphy. However, such approaches are costly and often require overnight treatment in clinics. With this in mind, the research presented here has emerged from the question: “Can data be easily collected and analyzed without causing discomfort to patients?” Therefore, the aim of this study is to provide a novel monitoring system for quantifying sleep quality. The data acquisition system is equipped with multimodal sensors, including a three-axis accelerometer and a pressure sensor. To identify sleep quality based on measured data, a novel algorithm, which uses numerous physiological parameters, was proposed. Such parameters include non-REM sleep time, the number of apneic episodes, and sleep durations for dominant poses. To assess the effectiveness of the proposed system, three participants were enrolled in this experimental study for a duration of 20 days. From the experimental results, it can be seen that the proposed monitoring system is effective for quantifying sleep quality.

Fog computing is a modern computing model which offers geographically dispersed end-users with the latency-aware and highly scalable services. It is comparatively safer than cloud computing, due to information being rapidly stored and evaluated closer to data sources on local fog nodes. The advent of Blockchain (BC) technology has become a remarkable, most revolutionary, and growing development in recent years. BT's open platform stresses data protection and anonymity. It also guarantees data is protected and valid through the consensus process. BC is mainly used in money-related exchanges; now it will be used in many domains, including healthcare; This paper proposes efficient Blockchain-based secure healthcare services for disease prediction in fog computing. Diabetes and cardio diseases are considered for prediction. Initially, the patient health information is collected from Fog Nodes and stored on a Blockchain. The novel rule-based clustering algorithm is initially applied to cluster the patient health records. Finally, diabetic and cardio diseases are predicted using feature selection based adaptive neuro-fuzzy inference system (FS-ANFIS). To evaluate the performance of the proposed work, an extensive experiment and analysis were conducted on data from the real world healthcare. The experimental results show that the proposed work efficiently predict the disease.

This paper presents a method for respiratory rate estimation using the camera of a smartphone, an MP3 player or a tablet. The iPhone 4S, iPad 2, iPod 5, and Galaxy S3 were used to estimate respiratory rates from the pulse signal derived from a finger placed on the camera lens of these devices. Prior to estimation of respiratory rates, we systematically investigated the optimal signal quality of these 4 devices by dividing the video camera's resolution into 12 different pixel regions. We also investigated the optimal signal quality among the red, green and blue color bands for each of these 12 pixel regions for all four devices. It was found that the green color band provided the best signal quality for all 4 devices and that the left half VGA pixel region was found to be the best choice only for iPhone 4S. For the other three devices, smaller 50 × 50 pixel regions were found to provide better or equally good signal quality than the larger pixel regions. Using the green signal and the optimal pixel regions derived from the four devices, we then investigated the suitability of the smartphones, the iPod 5 and the tablet for respiratory rate estimation using three different computational methods: the autoregressive (AR) model, variable-frequency complex demodulation (VFCDM), and continuous wavelet transform (CWT) approaches. Specifically, these time-varying spectral techniques were used to identify the frequency and amplitude modulations as they contain respiratory rate information. To evaluate the performance of the three computational methods and the pixel regions for the optimal signal quality, data were collected from 10 healthy subjects. It was found that the VFCDM method provided good estimates of breathing rates that were in the normal range (12-24 breaths/min). Both CWT and VFCDM methods provided reasonably good estimates for breathing rates that were higher than 26 breaths/min but their accuracy degraded concomitantly with increased respiratory rates. Overall, the VFCDM method provided the best results for accuracy (smaller median error), consistency (smaller interquartile range of the median value), and computational efficiency (less than 0.5 s on 1 min of data using a MATLAB implementation) to extract breathing rates that varied from 12 to 36 breaths/min. The AR method provided the least accurate respiratory rate estimation among the three methods. This work illustrates that both heart rates and normal breathing rates can be accurately derived from a video signal obtained from smartphones, an MP3 player and tablets with or without a flashlight.

Malware is 'malicious software' programs that carry out many of the cyberattacks on the Internet, including cybercrime, fraud, scams and nation-state cyberwar. These malicious software programs come in a wide range of different classifications such as viruses, Trojans, worms, spyware, botnet malware, ransomware, Rootkit, etc. Ransomware is class of malware that holds the victim's data hostage by encrypting the data on a user's computer to make it unavailable to the user and only decrypt it after the user pays a ransom in the form of a sum of money. To avoid detection, different variants of ransomware utilise one or more techniques in their attack flow including Machine Learning (ML) algorithms. There is, therefore, a need to understand the techniques used ransomware development and their deployment strategy in order to understand their attack flow better to develop appropriate countermeasures. In this paper, we propose DNAact-Ran, A Digital DNA Sequencing Engine for Ransomware Detection Using Machine Learning. DNAact-Ran utilises Digital DNA sequencing design constraints and k-mer frequency vector. To measure the efficacy of the proposed approach, we evaluated DNAact-Run on 582 ransomware and 942 goodware instances to measure the performance of precision, recall, f-measure and accuracy. Compared to other methods, the evaluation results show that DNAact-Run can predict and detect ransomware accurately and effectively.