Residual monomer contents and surface hardness are important factors in determining the serviceability of provisional restorations. The intent of this study was to systemically evaluate the effects of curing conditions on provisional polymethyl methacrylate (PMMA) resins which utilize a free-radical polymerization reaction. Combinations of the three curing factors of temperature, pressure, curing environment (water/air) were adjusted during the fabrication of autopolymerized specimen disks. The initial hardness of tested materials was measured with a microhardness tester 1 h after disc fabrication, and the amounts of residual methyl methacrylate (MMA) released into water were analyzed by reverse-phase HPLC after 7 d of water immersion. Results from multiple regressions showed that curing temperature was the dominant factor in improving resin surface hardness, whereas curing in water was the key factor for reducing the quantity of residual monomer. The pressure factor, which was thought to be critical for managing autopolymerized resins, showed no significant influences on the properties tested. ANOVA results showed that provisional PMMA resins cured in hot water, with or without pressure, significantly reduced the amount of residual MMA elution (up to 80%) and increased the microhardness values (up to 50%).

No abstract

No abstract

No abstract

The present investigation examined whether an association exists between betel quid chewing and signs of periodontal disease and determined the prevalence of Actinobacillus actinomycetemcomitans and Porphyromonas gingivalis by polymerase chain reaction. The periodontal status of 34 betel quid chewers and 32 non‐betel quid chewers were compared. A significantly higher prevalence of bleeding on probing was found in betel quid chewers than non‐chewers among the subjects with higher plaque level, greater gingival inflammation, deeper probing depth or greater attachment loss. Also, the results suggested that betel quid chewers may harbor higher levels of infection with A. actinomycetemcomitans and P. gingivalis than non‐betel quid chewers. The association persists after adjusting for severity of the clinical parameters. In conclusion, betel quid chewing was associated with a higher prevalence of bleeding on probing where higher clinical levels of disease existed, and with a likelihood of subgingival infection with A. actinomycetemcomitans and P. gingivalis.