Background and Objectives Silicon germanium (SiGe) is expected to be applied for the optical devices such as infrared sensors, because of its narrower band gap than Si. Therefore, it is important to understand the optical properties of SiGe. In general, SiGe films epitaxially grown on Si or Ge substrates are the candidate materials for the optical devices. Inhomogeneous dislocation and strain in the SiGe films may reduce process yields. Although there are some literatures regarding to the distribution of dislocations and strain in the SiGe films [1, 2], the optical properties have not been evaluated sufficiently yet. In this study, we investigate the distribution of optical properties in the SiGe films by spectroscopic ellipsometry. Experiments Graded SiGe buffer layers (10% Ge / μm) and strain-relaxed SiGe layers (6 μm) with Ge fraction of 20% and 50% were grown on 200 mm diameter Si (001) substrates by molecular beam epitaxy. It is widely recognized that the dislocation density and strain are reduced in the SiGe layer epitaxially grown on a graded buffer layer on a Si (001) substrate. Since the optical properties are affected by strain [3], this structure, which can reduce strain, is useful for applying SiGe films in optical devices. In order to investigate the distribution of the optical properties, strain and Ge fraction in the SiGe films, we measured several points from the center to the edge of the wafer by spectroscopic ellipsometry and X-ray diffraction (XRD). The spectroscopic ellipsometry measurements were performed with an incident angle of 70°, a 70 W xenon lamp as the light source, and a wavelength range of 200 to 1600 nm. For XRD, we measured the (004) plane using a Cu Kα X-ray source with a wavelength of 1.5406 Å. The lattice parameters were calculated based on the 004 diffraction peak from the SiGe films. Results and Discussion Figure 1 (a) and (b) show the distribution of the extinction coefficient in the SiGe films with Ge fraction of 20% and 50%, respectively. The distributions of the extinction coefficient in the infrared region are enlarged in these figures. We found that the extinction coefficient of SiGe (50%) is higher than that of SiGe (20%) in the near-infrared region, indicating that the higher Ge fraction is able to absorb longer wavelength light. From Fig. 1, it is clear that the SiGe wafer (50%) has a larger variation than the SiGe wafer (20%), especially in the long wavelength region. Figures 2 and 3 show XRD peak of SiGe films and the distribution of the lattice parameter in the SiGe films with Ge fraction of 20% and 50%, respectively. The lattice parameters of Si1-x Ge x assuming strain-free were calculated using Vegard's law (dx [Å] = 0.027x 2 + 0.2x + 5.431). From Fig. 3, it is clear that the SiGe wafer (50%) shows a larger variation than the SiGe wafer (20%) with respect to the lattice parameter. Since the lattice parameter of SiGe varies with the Ge fraction and strain state, first the cause of this variation can be cited that of the Ge fraction. The lattice parameters at the edge of the wafers are much larger than those at the center of the wafers, suggesting that variations in Ge fraction at the edge of the wafers. The same behavior has been observed in previous studies regarding SiGe wafers [1, 2]. Also, it is considered that the variations of the lattice parameter vary not only due to Ge fraction, but also residual strain. Although sample structures are designed to induce strain relaxation in SiGe films, it is considered that the strain in the epitaxially grown SiGe film on the graded buffer layer cannot be fully relaxed based on the results of XRD. These variations of Ge fraction and strain may cause the variation of the extinction coefficient of SiGe films. The result that the SiGe wafer (50%) has a larger variation than the SiGe wafer (20%) indicates that the inhomogeneity of the optical properties and the lattice parameter increase and it may reduce process yields with increasing Ge fraction, for SiGe films on Si substrates. References [1]. A. Ogura et al., Jpn. J. Appl. Phys. 45, 3007 (2006). [2]. Y. F. Tzeng et al., Appl. Phys. Express 3, 106601 (2010). [3]. Y. Ishikawa et al., Appl. Phys. Lett. 82, 2044 (2003). Figure 1
1. Background and purpose Silicon tin (SiSn) alloys are attractive candidate for the next-generation group-IV semiconductors. It is well known that Si and Ge change from indirect to direct transition types with the addition of Sn. Among them, SiSn alloys are expected to be applied for the near-infrared optical devices because it is predicted to become a direct band-gap appropriate for the optical communication with sufficient Sn content [1]. Although the Sn composition that changes from indirect to direct band-gap has been reported using several calculations, there are few reports of experimental results. In addition, the optical properties of single crystalline Si1-x Sn x have not been sufficiently clarified owing to the difficulty of crystal growth. In this study, we evaluated the optical properties to clarify the band structure of single crystalline Si1-x Sn x . 2. Experimental method Strained 30 nm-thick Si1-x Sn x films were grown on Si substrate by molecular beam epitaxy (MBE), and epitaxial growth was confirmed by X-ray diffraction (XRD) two-dimensional reciprocal space mapping (2DRSM) [2]. The Sn composition was determined by 2DRSM. The Sn fraction x of Si1-x Sn x samples used in this study were 0.005, 0.009, 0.018, 0.022, and 0.06. The spectroscopic ellipsometry measurements were performed with an incident angle of 70°, using a 70 W xenon lamp with a wavelength range of 200 to 1600 nm for the light source. The functions used in the analysis are the Tauc-Lorentz and Lorentz function. 3. Results and Discussion Figure 1(a) and (b) show real part and imaginary part of the complex dielectric functions for Si1-x Sn x (x=0.005 - 0.06) and pure-Si, respectively. From Fig. 1, it can be confirmed that the spectra shift with increasing Sn composition and the peaks appear around 1.8 eV and 2.8 eV for the samples with high Sn composition (2.2% and 6.0%). The peak shift characteristic with the addition of Sn is similar to the results of germanium tin (GeSn) [3]. The complex dielectric functions of the semiconductor include much information about the electronic band structure. In Fig. 1, the sharp peaks that are due to direct band transitions show what is known as critical points (CPs). In the case of Si, E'0 CP (Γ) and E 1 CP (L) energy are around 3.2 eV [4]. Therefore, it can be considered that the peak at 2.8 eV indicates the separation of the E'0 and E 1 CP energies due to the change in the band gap at the Γ point with the addition of Sn. The peak at 1.8 eV is unique to Si1-x Sn x , which is not found in Si. We consider that this peak is due to the split-off valence band caused by the Sn addition. The behavior of the valence band is strongly affected by strain. These results suggest a reduction of the band gap at the Γ point and the formation of an optical transition region due to the Sn addition, and reveal important findings for the application of SiSn for the near-infrared devices. Acknowledgment This work was partly supported by the Japan Society for the Promotion of Science (JSPS) (17J08240, 19K21971, and 21H01366). References [1] M. Kurosawa et al., Appl. Phys. Lett. 106, 171908 (2015). [2] R. Yokogawa et al., ECS Trans. 98. 291 (2020). [3] M. Medikonda et al., J. Vac. Sci. Technol. B 32, 061805 (2014). [4] P. Lautenschlager et al., Phys. Rev. B 36, 9 (1987). Figure 1
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.