We herein present a three-in-one nanoplatform for sensing, self-assembly, and cascade catalysis, enabled by cyclodextrin modified gold nanoparticles (CD@AuNPs). Monodisperse AuNPs 15-20 nm in diameter are fabricated in an eco-friendly way by the proposed one-step colloidal synthesis method using CD as both reducing agents and stabilizers. First, the as-prepared AuNPs are employed as not only scaffolds but energy acceptors for turn-on fluorescent sensing based on guest replacement reaction. Then, the macrocyclic supramolecule functionalized AuNPs can be controllably assembled and form well-defined one- and two-dimensional architectures using tetrakis(4-carboxyphenyl)porphyrin as mediator. Finally, in addition to conventional host-guest interaction based properties, the CD@AuNPs possess unpredictable catalytic activity and exhibit mimicking properties of both glucose oxidase and horseradish peroxidase simultaneously. Especially, the cascade reaction (glucose is first catalytically oxidized and generates gluconic acid and HO; then the enzymatic HO and preadded TMB (3,3',5,5'-tetramethylbenzidine) are further catalyzed into HO and oxTMB, respectively) is well-achieved using the AuNPs as the sole catalyst. By employing a joint experimental-theoretical study, we reveal that the unique catalytic properties of the CD@AuNPs probably derive from the special topological structures of CD molecules and the resulting electron transfer effect from the AuNP surface to the appended CD molecules.

The electrosynthesis from 5‐hydroxymethylfurfural (HMF) is considered a green strategy to achieve biomass‐derived high‐value chemicals. As the molecular structure of HMF is relatively complicated, understanding the HMF adsorption/catalysis behavior on electrocatalysts is vital for biomass‐based electrosynthesis. The electrocatalysis behavior can be modulated by tuning the adsorption energy of the reactive molecules. In this work, the HMF adsorption behavior on spinel oxide, Co3O4 is discovered. Correspondingly, the adsorption energy of HMF on Co3O4 is successfully tuned by decorating with single‐atom Ir. It is observed that compared with bare Co3O4, single‐atom‐Ir‐loaded Co3O4 (Ir‐Co3O4) can enhance adsorption with the CC groups of HMF. The synergetic adsorption can enhance the overall conversion of HMF on electrocatalysts. With the modulated HMF adsorption, the as‐designed Ir‐Co3O4 exhibits a record performance (with an onset potential of 1.15 VRHE) for the electrosynthesis from HMF.

Black phosphorus is a layered semiconducting allotrope of phosphorus with high carrier mobility. Its monolayer form, phosphorene, is an extremely fashionable two-dimensional material which has promising potential in transistors, optoelectronics and electronics. However, phosphorene-like analogues, especially phosphorene-based heterostructures and their layer-controlled electronic properties, are rarely systematically investigated. In this paper, the layer-dependent structural and electronic properties of phosphorene-like materials, i.e., mono- and few-layer MXs (M = Sn, Ge; X = S, Se), are first studied via first-principles calculations, and then the band edge position of these MXs as well as mono- and few-layer phosphorene are aligned. It is revealed that van der Waals heterostructures with a Moiré superstructure formed by mutual coupling among MXs and among MXs and few-layer phosphorene are able to show type-I or type-II characteristics and a I-II or II-I transition can be induced by adjusting the number of layers. Our work is expected to yield a new family of phosphorene-based semiconductor heterostructures with tunable electronic properties through altering the number of layers of the composite.

First-principles calculations were employed to explore the electronic and magnetic properties of a twodimensional (2D) SnSe 2 monolayer sheet and its derived onedimensional (1D) nanoribbons and nanotubes. The results unveiled that the semiconductor−metal or metal−semiconductor transition can be realized by subtly controlling the strain for all these nanostructures. Surprisingly, without introduction of impurities and the absence of transition metal atoms, a −10% compressive strain can induce magnetic behaviors in SnSe 2 armchair nanoribbons and the emerged magnetic moment increases rapidly and linearly with the increase of strain. The magnetism is found to be stemmed from the nonmetallic anionic Se atom at the ribbon edge. The tunable electronic and magnetic properties can be well understood through the analysis of partial charge density distribution and partial density of states. It was found that the direction of applied strain is a determined factor that can affect the energy shift of Se p orbital, leading to different composition of the states near the Fermi level. Finally, the stabilities of these SnSe 2 nanostructures were evaluated for the possibility of experimental realizations. We believe that our results will provide useful information for their potential applications in electromechanical nanodevices, which will stimulate further experimental and theoretical investigations in this field.

We demonstrate the 2-D anisotropic formation of ultrathin free-floating Pt nanoplates from the assembly of small nanocrystals using T7 peptide (Ac-TLTTLTN-CONH 2 ). As-formed nanoplates are rich in grain boundaries that can promote their catalytic activities. Furthermore, we demonstrate that a minor number of Pd atoms can selectively deposit on and stabilize the grain boundaries, which leads to enhanced structure stability. The Pd-enhanced Pt polycrystal nanoplates show great oxygen reduction reaction activities with 15.5 times higher specific activity and 13.7 times higher mass activity than current state-of-the-art commercial Pt/C electrocatalysts as well as 2.5 times higher mass activity for hydrogen evolution reaction compared with Pt/C.

Lithium sulfur (Li–S) batteries can offer great opportunities for the next-generation energy storage systems with tremendous energy density. However, challenges still exist in practical Li–S batteries including low sulfur utilization, and poor cycling stability and rate capability. Herein, we propose a novel hybrid catalyst structure by in situ implanting nanocrystal CoS2 in three-dimensional honeycomb-like hierarchical porous graphitic carbon (HPGC) for high-performance Li–S batteries. A unique synergistic absorption-catalysis-functional effect is demonstrated by comprehensive experimental and theoretical analysis: strong physical and chemical co-absorption effects are originated from the large quantity of microporous HPGC and the polar surface of metallic CoS2; the introduced nanocrystal CoS2 with a large specific area can impose an exceptional catalytic effect on the liquid–liquid, solid–liquid, and solid–solid phase redox reactions in Li–S batteries; the reaction dynamics are further guaranteed by the multifunctional properties of the HPGC backbone, including the capabilities in polysulfide sustention, reaction product transportation, electrolyte compensation, and efficiency in assisting diverse electrochemical reaction dynamics. In this way, our results not only develop a novel CoS2@HPGC structure, but also provide fundamental understanding on the catalytic dynamics during each reaction process. Moreover, we further propose the necessity and philosophy of the rational design of catalysts’ special structure, which can fulfill the functional dynamics requirements of Li–S batteries, and can be promoted to other Li–S-related cathode design and composite catalytic structure design.

No abstract

Herein we report a gentle seedless and surfactant-free method for the preparation of clean-surface porous platinum nanoparticles. In terms of electrocatalytic CH(3)OH oxidation, the clean-surface porous platinum exhibited better performance than platinum nanoparticles and a commercial Pt/C catalyst. The porous nanostructures exhibited 2.26-fold higher mass activity and 2.8-fold greater specific activity than the Pt/C catalyst. More importantly, three typical surfactants, cetyltrimethylammonium bromide/chloride (CTAB/C), poly(vinylpyrrolidone), and sodium dodecyl sulfate, were chosen to study the inhibition effect of surfactants on electrocatalytic performance. It was observed that the surfactants led to a clear selective decrease in electrocatalytic performance. CTAB/C inhibited the catalytic activity the most due to the stronger interaction between the OH-enriched platinum surface and the positively charged molecules. Thus, this work indicates that these clean-surface porous platinum nanoparticles may be used as efficient catalysts for direct methanol fuel cells and provides a greater understanding of the inhibition effects of surfactants on catalytic activity.