Titanium alloys are widely used in aerospace, chemical engineering and medicine because of their excellent tensile, fatigue strength and corrosion resistance. For aerospace titanium alloys, fatigue performance is an important parameter, especially as a structural material. Welding is an indispensable method. After welding, there is a large unevenness in the structure and mechanical properties of the welded joint. Fatigue performance also has a profound effect. This article has done a deep research on the fatigue performance of titanium alloy welded streets, using ANSYS software to calculate and analyze the stress concentration of welded joints, observe and analyze the welding defects on fatigue fractures, and discuss the effect of welding defects on fatigue behavior The equivalent residual stress after spot welding at the center of the joint weld obtained by conventional laser welding near the welding end position is 547 MPa, of which the longitudinal residual stress along the weld direction is tensile stress, the magnitude is 482 MPa, and the transverse direction perpendicular to the weld direction The residual stress is a compressive stress of 114.0 MPa, and the equivalent residual stress of the weld is reduced after the use of SGCW technology. The equivalent residual stress at this point is reduced to 489 MPa, which is a reduction of nearly 12%.
AlN is an extremely chemically stable material that can withstand high temperature impacts and can be used as a coating against high temperature oxidation. In this paper, AlN films were grown on Si (111) substrates using pulsed chemical vapor deposition with a metal-organic source and ammonia as precursors followed by high-temperature in situ annealing and material physical characterization. The effects of temperature and plasma source on the AlN films were investigated, and it was concluded that the higher the temperature, the higher the growth rate of the AlN films and the lower the oxidation level. The plasma source pulsed mode showed higher growth rate and stronger aluminum signal, but its oxidation level was also higher. The plasma source normally open mode has a more desirable nitrogen signal.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.