No abstract

No abstract

Physicochemical characteristics of Hibiscus cannabinus (kenaf) fibers from Burkina Faso were studied using X-ray diffraction (XRD), infrared spectroscopy, thermal gravimetric analysis (TGA), chemical analysis and video microscopy. Kenaf fibers (3 cm long) were used to reinforce earth blocks, and the mechanical properties of reinforced blocks, with fiber contents ranging from 0.2 to 0.8 wt%, were investigated. The fibers were mainly composed of cellulose type I (70.4 wt%), hemicelluloses (18.9 wt%) and lignin (3 wt%) and were characterized by high tensile strength (1 ± 0.25 GPa) and Young’s modulus (136 ± 25 GPa), linked to their high cellulose content. The incorporation of short fibers of kenaf reduced the propagation of cracks in the blocks, through the good adherence of fibers to the clay matrix, and therefore improved their mechanical properties. Fiber incorporation was particularly beneficial for the bending strength of earth blocks because it reinforces these blocks after the failure of soil matrix observed for unreinforced blocks. Blocks reinforced with such fibers had a ductile tensile behavior that made them better building materials for masonry structures than unreinforced blocks.

No abstract

No abstract

In developing countries, most of the population cannot afford conventional building blocks made with the sand-cement mixture. In addition, these blocks do not provide thermal comfort and have a high embodied energy compared to vernacular materials. The main objective of this work was to produce low cost, resistant and durable (good resistance to water) blocks with a thermal behaviour enabling quality comfort indoor. For that purpose, the effects of cow-dung on microstructural changes in earth blocks (adobes) are investigated by means of X-ray diffraction, thermal gravimetric analyses, scanning electronic microscopy coupled with energy dispersive spectrometry, and video microscopy. The effects of these changes on the physical properties (water absorption and linear shrinkage) and mechanical properties (flexural and compressive strengths) of adobe blocks are evaluated. It is shown that cow-dung reacts with kaolinite and fine quartz to produce insoluble silicate amine, which glues the isolated soil particles together. Moreover, the significant presence of fibres in cow-dung prevents the propagation of cracks in the adobes and thus reinforces the material. The above phenomena make the adobe microstructure homogeneous with an apparent reduction of the porosity. The major effect of cow-dung additions is a significant improvement in the water resistance of adobe, which leads to the conclusion that adobes stabilized by cow-dung are suitable as building materials in wet climates.

No abstract

The main objectives of this work were to manufacture adobes with good mechanical properties, even in a wet environment, and low thermal conductivity so as to give the population homes that provided better thermal comfort than cement-based constructions. For this purpose, clayey raw material from Burkina Faso, mainly composed of quartz (49 wt.%), kaolinite (28 wt.%), goethite (7 wt.%) and muscovite (9 wt.%) was mixed with up to 12 wt.% of cement to manufacture adobes. Various characterization techniques were implemented to assess the microstructure of these materials: X-ray diffraction, infrared spectrometry, differential scanning calorimetry, scanning electron microscopy and energy dispersive spectrometry. Their physical properties were also investigated (through water absorption, spray test, apparent density, porosity and thermal conductivity) as their mechanical