SummaryPhotosystem II (PSII) is a huge membrane-protein complex consisting of 20 different subunits with a total molecular mass of 350 kDa for a monomer, and catalyzes light-driven water oxidation at its catalytic center, the oxygen-evolving complex (OEC) [1][2][3] . The structure of PSII has been analyzed at 1.9 Å resolution by synchrotron radiation X-rays, which revealed that OEC is a Mn4CaO5 cluster organized in an asymmetric, "distorted-chair" form 4 . This structure was further analyzed with femtosecond X-ray free electron lasers (XFEL), providing the "radiation damage-free" 5 structure. The mechanism of O=O bond formation, however, remains obscure due to the lack of intermediate state structures. Here we report the structural changes of PSII induced by 2-flash (2F) illumination at room temperature at a resolution of 2.35 Å using time-resolved serial femtosecond crystallography (TR-SFX) with an XFEL provided by the SPring-8 angstrom compact free-electron laser (SACLA). Isomorphous differenceFourier map between the 2F and dark-adapted states revealed two areas of apparent changes; they are around QB/non-heme iron and the Mn4CaO5 cluster. The changes around the QB/non-heme iron region reflected the electron and proton transfers induced by the 2F-illumination. In the region around the Mn4CaO5 cluster, a water molecule located 3.5 Å from the Mn4CaO5 cluster disappeared from the map upon 2Fillumination, leading to a closer distance between another water molecule and O4, suggesting also the occurrence of proton transfer. Importantly, the 2F-dark isomorphous difference Fourier map showed an apparent positive peak around O5, a unique μ3-oxo-bridge located in the quasi-center of Mn1 and Mn4 4,5 . This suggests an insertion of a new oxygen atom (O6) close to O5, providing an O=O distance of 1.5 Å between these two oxygen atoms. This provides a mechanism for the O=O bond formation 4 consistent with that proposed by Siegbahn 6,7 . Fig. 1a shows organization of the electron transfer chain of PSII in a pseudo-C2 symmetry by two subunits D1 and D2. The water-oxidation reaction proceeds via the Si-state cycle 8 (with i=0-4), where dioxygen is produced in the transition of S3→(S4)→S0 (Fig. 1b). The high-resolution structures of PSII analyzed so far were for the dark-stable S1 state 4,5 , although a few studies on the low-resolution intermediate S-state structures have been reported by TR-SFX [9][10][11] . During the revision of our manuscript, Young et al. reported a 2F-illuminated state structure at 2.25 Å resolution where no apparent changes around O5 were observed 12 , although estimations of the resolution could yield somewhat different values so that small movement of some water molecules may escape the detection. In order to achieve resolution high enough to uncover small structural changes induced by flash illuminations yet allowing Si-state transition to proceed efficiently, we determined the optimal crystal size of PSII with a maximum length of 100 µm, which diffracted up to a resolution of 2.1 Å by a SACLA-XFEL ...

No abstract

Biotin protein ligase (BPL) catalyzes the biotinylation of the biotin carboxyl carrier protein (BCCP) only at a special lysine residue. Here we report the first structure of BPL⅐BCCP complex crystals, which are prepared using two BPL mutants: R48A and R48A/K111A. From a detailed structural characterization, it is likely that the mutants retain functionality as enzymes but have a reduced activity to produce the reaction intermediate biotinyl-5-AMP. The observed biotin and partly disordered ATP in the mutant structures may act as a non-reactive analog of the substrates or biotinyl-5-AMP, thereby providing the complex crystals. The four crystallographically independent BPL⅐BCCP complexes obtained can be classified structurally into three groups: the formation stages 1 and 2 with apo-BCCP and the product stage with biotinylated holo-BCCP. Residues responsible for the complex formation as well as for the biotinylation reaction have been identified. The C-terminal domain of BPL shows especially large conformational changes to accommodate BCCP, suggesting its functional importance. The formation stage 1 complex shows the closest distance between the carboxyl carbon of biotin and the special lysine of BCCP, suggesting its relevance to the unobserved reaction stage. Interestingly, bound ATP and biotin are also seen in the product stage, indicating that the substrates may be recruited into the product stage complex before the release of holo-BCCP, probably for the next reaction cycle. The existence of formation and product stages before and after the reaction stage would be favorable to ensure both the reaction efficiency and the extreme substrate specificity of the biotinylation reaction.

No abstract