The material strength of rolled steel sheet for car bodies is increasing considerably. It has been experientially known that the die deflection affects the springback, but there are few experimental verification cases. In this study, two bending dies with different rigidity but the same shape were manufactured. The springback of panels bended by each die was compared in detail. Using 590MPa class and 980MPa class steel sheets, the deformation of the dies due to bending also measured. The springback and deflection of the die were clearly large using the low rigidity die. From these results, it was suggested that it is necessary to consider the die deflection for accurate springback prediction of bending.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.