No abstract

No abstract

Thermosetting blends of an aliphatic epoxy resin and a hydroxyl‐functionalized hyperbranched polymer (HBP), aliphatic hyperbranched polyester Boltorn H40, were prepared using 4,4′‐diaminodiphenylmethane (DDM) as the curing agent. The phase behavior and morphology of the DDM‐cured epoxy/HBP blends with HBP content up to 40 wt % were investigated by differential scanning calorimetry (DSC), dynamic mechanical analysis (DMA), and scanning electron microscopy (SEM). The cured epoxy/HBP blends are immiscible and exhibit two separate glass transitions, as revealed by DMA. The SEM observation showed that there exist two phases in the cured blends, which is an epoxy‐rich phase and an HBP‐rich phase, which is responsible for the two separate glass transitions. The phase morphology was observed to be dependent on the blend composition. For the blends with HBP content up to 10 wt %, discrete HBP domains are dispersed in the continuous cured epoxy matrix, whereas the cured blend with 40 wt % HBP exhibits a combined morphology of connected globules and bicontinuous phase structure. Porous epoxy thermosets with continuous open structures on the order of 100–300 nm were formed after the HBP‐rich phase was extracted with solvent from the cured blend with 40 wt % HBP. The DSC study showed that the curing rate is not obviously affected in the epoxy/HBP blends with HBP content up to 40 wt %. The activation energy values obtained are not remarkably changed in the blends; the addition of HBP to epoxy resin thus does not change the mechanism of cure reaction of epoxy resin with DDM. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 889–899, 2006

Sugarcane fiber (i.e. bagasse) lignin has a larger fraction of aromatics unsubstitution in the ortho position than hardwood or softwood lignin and hence has the greater ability to be derivatized. Furthermore, organosolv lignin has a higher purity than sulfonated and kraft lignins. This work examines the purification of organosolv lignin derived from bagasse and the physico‐chemical properties of the lignin and lignin‐phenol formaldehyde (PF) resin coatings, and composites. The wetability tests have shown that lignin and lignin‐PF resin films are effective water barrier coatings, though the contact angles of lignin‐PF resin films were considerably less than the wax films. The overall mechanical properties (i.e. peak stress, peak strain and modulus) of the bagasse fiber composites were lower than the values obtained with the composites without the inclusion of bagasse fiber. Copyright © 2007 John Wiley & Sons, Ltd.

No abstract

ABSTRACT:The radiolysis of a poly(ethylene-co-propylene), Elpro grade P 750 J, marketed by Thai Polypropylene Co. Ltd. for the manufacture of medical goods, was investigated at ambient temperature and melt rheology measured. The roles of calcium stearate, blended with the Elpro as a processing aid, and dioctyl phthalate (DOP), added in various amounts as a radical scavenger, were assessed. Following radiolysis, GЈ and the viscosity of the polymer melts at 453 K both decreased with increasing radiation dose, even when the mobilizer was present. The results indicated that although the DOP did scavenge radicals, it did not protect the polymer from net chain scission in a low-dose regimen. The value of (G S Ϫ 4G X ) was approximately 0.6 -0.7.