No abstract

The electrostatic behavior of the charge-regulated surfaces of Gram-negative Escherichia coli and Gram-positive Bacillus brevis was studied using numerical modeling in conjunction with potentiometric titration and electrophoretic mobility data as a function of solution pH and electrolyte composition. Assuming a polyelectrolytic polymeric bacterial cell surface, these experimental and numerical analyses were used to determine the effective site numbers of cell surface acid-base functional groups and Ca(2+) sorption coefficients. Using effective site concentrations determined from 1:1 electrolyte (NaCl) experimental data, the charge-regulation model was able to replicate the effects of 2:1 electrolyte (CaCl(2)), both alone and as a mixture with NaCl, on the measured zeta potential using a single Ca(2+) surface binding constant for each of the bacterial species. This knowledge is vital for understanding how cells respond to changes in solution pH and electrolyte composition as well as how they interact with other surfaces. The latter is especially important due to the widespread use of the Derjaguin-Landau-Verwey-Overbeek (DLVO) theory in the interpretation of bacterial adhesion. As surface charge and surface potential both vary on a charge-regulated surface, accurate modeling of bacterial interactions with surfaces ultimately requires use of an electrostatic model that accounts for the charge-regulated nature of the cell surface.

No abstract

Experiments were conducted using enterohemorrhagic Escherichia coli O157:H7 cells to investigate the influence of extracellular macromolecules on cell surface properties and adhesion behavior to quartz sand. Partial removal of the extracellular macromolecules on cells by a proteolytic enzyme (proteinase K) was confirmed using Fourier transform infrared spectroscopy analyses. The proteinase K treated cells exhibited more negative electrophoretic mobility (EPM) at an ionic strength (IS) e 1 mM, a slightly lower isoelectric point, and were less hydrophobic as compared to the untreated cells. Potentiometric titration results indicated that the total site concentration (i.e., the total amount of exposed functional groups per cell) on the treated cells was approximately 22% smaller than the untreated cells, while the dissociation constants were almost identical. Analysis of the EPM data using soft particle theory showed that the removal of extracellular macromolecules resulted in polymeric layers outside the cell surface that were less electrophoretically soft. The more negative mobility for the treated cells was likely due to the combined effects of a change in the distribution of functional groups and an increase in the charges per unit volume after enzyme treatment and not just removal of extracellular macromolecules. The proteolytic digestion of extracellular macromolecules led to a significant difference in the cell adhesion to quartz sand. The adhesion behavior for treated cells was consistent with DLVO theory and increased with IS due to less negativity in the EPM. In contrast, the adhesion behavior of untreated cells was much more complex and exhibited a maximum at IS ) 1 mM. The treated cells exhibited less adhesion than the untreated cells when the IS e 1 mM due to their more negative EPM. However, when the IS g 10 mM, a sudden decrease in the removal efficiency was observed only for the untreated cells even through EPM values were similar for both treated and untreated cells. This result suggested that an additional non-DLVO type interaction, electrosteric repulsion, occurred at higher IS (g10 mM in this study) for the untreated cells due to the presence of extracellular macromolecules that hindered cell adhesion to the quartz surface. This finding provides important insight into the role of macromolecule-induced E. coli O157:H7 interactions in aquatic environments.