This paper aims at solving the material durability problem caused by spraying deicing salt on pavement concrete in the northern winter. Super absorbent polymer (SAP) was adopted as an internal curing agent to enhance the durability of pavement concrete. Curing parameters including particle size and dosage of SAP and curing condition were optimized based on mortar tests by means of the grey target decision method. The deterioration rule of durability and mechanical properties of pavement concrete internally cured by different SAP dosages after salt freeze–thaw cycles were explored through rapid freeze–thaw test. Combined with the characteristics of pore structure, hydration and microstructure, the influence mechanism of SAP on the salt freeze–thaw resistance of pavement concrete was revealed. The experimental results showed that: (i) The reduction in mass loss rate and relative dynamic modulus was significantly improved by SAP internal curing with moderate dosage; (ii) The more freeze–thaw cycles the specimen underwent, the greater the increase in strength; (iii) After 75 cycles, the chloride ion erosion depth could be decreased by approximately 23.18%. Moreover, the addition of SAP could refine the pore size, inhibit the generation of shrinkage microcracks, and promote the degree of cement hydration in the late stage, which improved the internal density of the cement concrete structure. Therefore, the deterioration of pavement under the coupling effect of salt freeze–thaw was reduced.

To clarify the influencing mechanism of superabsorbent polymer (SAP) internal curing agent on the carbonation resistance of cement concrete, accelerated carbonation experiment was conducted to explore the effect of particle size and dosage of SAP on carbonation depth. The hydration performance of internally cured concrete at different ages was studied by Fourier transform infrared spectroscopy (FTIR) test and X-ray diffraction (XRD) test. Combined with the scanning electron microscope (SEM) test, the hydration filling effect of internal curing on the microstructure of concrete was analyzed; meanwhile, the influence mechanism of SAP on carbonation resistance was revealed. The results showed that (i) when the particle size and dosage of SAP were 100 mesh and 0.200%, the carbonation depth of internally cured concrete was only 56.5% of the control group on day 28; (ii) the Ca(OH)2 absorption peak area of SAP-concrete in the FTIR spectra could be increased by 3.38 times than that of the control group, and more C2S and C3S were translated into Ca(OH)2, which helped to improve the hydration degree of cement concrete; (iii) the hydration products of day 56 were increased significantly and the remaining pores formed by SAP gels were gradually filled by hydration products, which enhanced the compactness and carbonation resistance of cement concrete.

The water absorption and release properties of superabsorbent polymers’ (SAP) internal curing agent are affected by many factors, such as solution properties, the ambient temperature and humidity and the particle size of SAP, which determine the curing effect and the durability of cement concrete structures directly. In this paper, the variation rule of the water absorbing capacity of SAP in simulated cement paste under different solutions and environmental conditions was studied. Based on microscopic image technology, the dynamic swelling behavior of the SAP particles was explored. The water release performance of SAP in cement paste was analyzed by both the tracer method and the negative pressure method. The results show that the water absorption of SAP in cement paste varied from 27 to 33 times. The ionic valence had a significant effect on the water absorption capacity of SAP, which suggests that the larger the ionic radius, the lower the absorption of SAP. The higher the temperature of the solution, the greater the water absorption rate of SAP. While the SAP particle size was less than 40–80 mesh, a slight ‘agglomeration effect’ was prone to occur, but the absorption state of SAP was more stable. Based on the swelling kinetic equation of SAP and the time-dependent swelling morphology of SAP in cement paste, a swelling kinetic model was established. The water release performance of SAP was less affected by the capillary negative pressures, and it would not release the water prematurely during the plastic stage, which was conducive to the continuous internal curing process of hardened paste in the later stage.